Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Drycell Plates High Degradation Rate?

Started by Z-Force, July 13, 2018, 01:47:27 PM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Z-Force

Hello Oxyhydrogen Enthusiasts,

I have built my first drycell oxyhydrogen generator and tested it yesterday. The test was successful as the drycell worked within design parameters. But one thing worried me when I disassembled the cell. The drycell was only operating for max. 10 minutes and yet the plates were visibly degraded. I have attached some pictures of the plates. Is that normal? This is my very first drycell so I apologize if my question is "too basic".

Here are the technical data:
The whole setup was a drycell connected to a electrolyte container and a bubbler. The Drycell was powered by an adjustable transformer
that together with a power diode fed the cell with a "half-periodic sine wave".

The drycell had 24 plates, 23 chambers. The plates were ANSI 316L/1.4404 stainless steel dimensioned 20x20 cm^2 with an active surface of 16x16 cm^2 and a thickness of 1 mm. The drycell was energized at its endplates, i.e., the configuration was [+ NNNNN... -]
The current to the cell was controlled by the electrolyte concentration, the distance between each plate and the variable voltage.
Since the plate spacing was approximately 1mm and  the cell was designed to operate at 2-2.5V per chamber with a max current draw of 18A, the potassium hydroxide electrolyte concentration amounted to 26.5g/liter. Distilled water was used, although I am not sure about its purity grade.
The gaskets between the plates were simple PVC squares.

The continuous operation of the drycell was 10 min. at 30-35V and an average current draw of 6 A.
When disassembling the cell I noticed that the plates and the electrolyte were getting warm, which must occur due to the voltage drop across the drycell, but the plates were discolored and had a "rusty" appearance. The electrolyte had a brownish color which indicates corrosion.
Is that normal for such a short operation time or am I just a little too worried about my babys :) ? Is the corrosion rate going down after the first layer of rust due to a protection layer?


Greetings,
Z