Newton's Magnets

[Floor]

@ Vidar

With the shield magnet fixed in the position
you illustrate there SHOULD be zero torque.
(this is good)

It seems to me that with the right timing of an insertion and
removal of the shield magnet your design could work.  Your
output magnets are shielded well before they are directly
opposite one another  (this is also good).

But the shield magnet would need to slide (up in your drawing) a little bit,
JUST AFTER the two rotating magnets are directly opposite
each other (this will give a little torque). 

But then the shield will be in the wrong position
for the next magnets, and so,  it needs to be returned to
its original position before they get there.

Try both shield positions in femm. 
One will give torque, the other will not.
You need both.

https://www.dailymotion.com/video/x6gzr2q

Today is Quatro de Julio (the 4th of july).
Its the day Americans celebrate their  "independence".

The first Americans lost their independence to the
Europeans,  because they had little immunity to the strange
diseases the Europeans brought with them. 

Neither did they posse the hard technologies / weapons, which the
Europeans had sacrificed the welfare of the earth to manufacture.

They had no faciest / corporate like,  government to brain wash
the people into blind soldier obedience.

The new Americans were surfs,  peons, and  slaves.  They still are.

Cages of steel aren't much needed if the peoples hearts and minds are
already imprisoned.

Love shall overcome fear.

            peace out
                      floor

[Floor]

@ lowQ

Designs (like yours) which are attempts to directly cause rotation
with the magnets are a bust (as far as I have seen).

The Newton's magnets design, is based upon hard right angle interactions.

This is the wrong topic to present either a new or a rotary design in.

This topic is about the design "Newton's magnets".

Please see the attached PDF file below "Newtons magnets.PDF"

   thanks
       floor

[Floor]

@ All readers

This is a link to a short video of the Newtons magnet demonstrated.

https://www.dailymotion.com/video/x6gzr2q

floor

[tinman]

Chet posted my video in the other thread,but i will post it here as well,as this thread seems dedicated to the gating effect you have discovered Floor.

The first video is just a small test rig i threw together to see if there were any notable reaction forces--and none were found.

So i decided to put together a rotary design of mine,using Floors gate design.
The second video shows the 3D printed parts i have so far,but i decided to make the drum and gear 1 piece. Those new parts are on the printer ATM.

Anyway,you get the idea of what i am trying to do,and make the build easier.

It would seem, ATM anyway,that Floor's gate design may be what we have been looking for.
Keep up the good work Floor 

Sorry about the printer noise in the second video.
I didn't think it would be that loud

https://www.youtube.com/watch?v=rRmbekUqJcs

https://www.youtube.com/watch?v=KhyfD1GiCXU

[Floor]

Thanks Tinman / Chet et. all.

The magnets motion and measurement topic
has a lot of design variations posted in it and also
some very good explinations of the how and whys.

Lots of drawings  and links to 19 short videos.

Tinman, the design your are looking at is there as well.

See file below.           

     floor