Mgnetic shield?

[telecom]

The only reliable way to overcome the shield problem is connect two cifta units
back to back, the way they are now.
Then rigidly connect shields.

[telecom]

When you stack several small magnets together, the polarity of them getting rearranged,
and out of several small magnets appears one big magnet, divided in the middle with
north/south polarity.

[Floor]

The only reliable way to overcome the shield problem is connect two cifta units
back to back, the way they are now.
Then rigidly connect shields.

Which citfta unit?
Last I looked,  he had presented 3 variatiions.

[Floor]

I put together two repelling magnets, opposing each other.
I inserted a similar magnet between them.
It was attracted to one magnet, and  simultaneously repelled by another.
I tried pulling it out - the force of pulling out is considerable, so high, that I couldn't pull with my fingers.
Attaching the image - couldn't place camera at the different angle, since one hand was holding the setup.

This is not one of the designs which I had presented. Apparently, it is a misinterpretation one of the designs I presented.  Where that misinterpretation got started ?  Lumen ? Tinman ? and apparently by you as well ?  I don't much care at this point.

Although I have since, addressed it on several accounts, and I'll say it again, for those whats hearing impaired.  Not a design I had presented.

But here is the solution to it's "problems" if you are so inclined as to grok it.

               floor

[Floor]

Next......

Will the shielding magnets, prevent the repelling of the
output magnets when it is between them ?

Will the shielding magnets be easilly removed from or
installed into between the output magnets ?

       tun in next week