Creating TPU Steven_Mark

[Toolofcortex]

Yeah it will be a big operation. For big balls alpha male, armed with much $, much skill, and Bruce_TPU videos.

I can almost taste the free energy, feel the heat of a constantly heated pool parties yeah...

and also, I think it should be bifilar wound, the core loop made of alloy wire.

This should be a non inductive wound wire resistor, as to make the wire in "reset mode" as quick as possible, before any current was ever put in it.

As it was when it was "in synch" with the earth.

[onepower]

My only question would be is anyone here not a paid corporate shill or fucking psychopath spamming the threads with incoherent psychobabble?.

[sm0ky2]

It's just the same one from before he changed his name


Out of hundreds of comments and replies he has had absolutely
nothing of value to add to any threads he posted in....


The few rare occasions I thought he actually said something useful....
Turns out he was quoting someone earlier in the discussion.


Not sure what motivates someone to waste their time with nonsense
and naysayersness. And yes psychobabble is probably the appropriate term.


If he spent half the energy and time actually being helpful, he has the potential
to help push one of these technologies along.
Doubtful that he will, but I'm somewhat of an optimist when it comes to humans.

[Toolofcortex]

I have already said that everything Bruce said is important and that all his videos were important.

Over unity is a lonely quest, and the higher you get the more lonely you are.

Making you all completely useless.

You people are too lazy to even save videos.

[sm0ky2]

If you start with the stiffler circuit he gives you detailed instructions
How to measure and test what we are doing.
How the Impulse stacks up over time.
Once you learn how it works, you can move on to a more compact design
Where the coils sit inside one another.


Get that to work with a known frequency impulse.
At no distance.
Now you have a TPU.


Build another amplifier to pick up the same impulse at a distance.
Now you have wireless energy transmission.


Now here's the part where this technology diverts from standard
waveform transformation:
In practice and theory we assume a condition on non-interference.
If otherwise, we create a known condition of destructive interference.
(remember the ferrite beads and ominous resistors?)


These circuits work on another principal, that of constructive interference.
We learn this in school, then the lesson goes immediately into how to get rid of it.
Go back to the beginning, the math is all there in your book. We just don't use it.


Remember the experiment with the single fixed-end rope, that is given an impulse
at a set frequency proportional to a wavelength division of the rope length.
What happens?
This is the same as when wind tears down a bridge, or the Tesla earthquake machine.
Our human solution? Wind disruptors!!! Get rid of all that free energy, because it's more
than we used to build the bridge in the first place!


A small impulse, amplified and stacked up over time can amount to near infinite energy.
(actually only up to the input of the source over time, but SM's source is bigger than us)




Understand this device is based on well known and well established physical properties of
the universe.
Just not ones that are prevalent in our current society. (This was not always the case)
Look at the dimensions and symmetry of oldworld architecture.
Some of the ones that are still intact play natural music when the wind blows.
And create physical vibration in walls, towers, and fenceposts that can power all sorts of
generators. Simple vibrational generators, the gave electricity to civilizations far in the past.
Something we only recently "rediscovered".


It seems like a lot to take in, but those of us that were here 20 years ago watched it happen
in our own time with the Solar Death Ray of Archimedes (356 B.C.)
And the Eric Jacqmain adventures that brought the technology into our modern world.
Today there are massive solar deathrays powering cities worldwide.


Never underestimate the work we do here.
Bringing technological awareness to the public is the first step towards freeing ourselves
from the economic slavery enforced upon us by the capitalist regime.