Creating TPU Steven_Mark

[sm0ky2]

Interesting historical fact:


Bells were never bells! We invented a reverse use for the device
By ADDING a hammer inside!
They were originally sound RECIEVERS / resonators
and physically connected to the substructure NOT "hanging"!


The sound of the air passing through the towers caused a resonant
vibration that rung the entire tower which in turn rang the larger building
They constantly produced sound, which is why they were destroyed by our
civilization.


The vibration of the metal inside the stone structures caused electric pressure
The rising amplitude gave it tension.
It is described this way by the old world very explicitly.


They used the energy to operate water and air compressors, that work differently
than ours do today. Without valves or separated chambers.
But rather pressure built up by motion such as that of the wind or a flowing river.
Fountains and wind powered channels are still functional around the world today.
Operating on free energy designed into the construction.
The same energy was converted into electricity and heat.
The oldest "induction heater" sits in a museum in Suzdal, dated to some 900 yrs ago.
4ftx4ftx12ft tall, and was known to heat the building it sits in.
Completely made of solid ceramic with 1/2" coils of an iron alloy wrapped through its'
interior, powered by electric oscillations the building harnessed.


The buildings were gigantic tank circuits designed to resonate from natural sources.
Just like TPU, stiffler 2&3coil, bendini , Tesla


A guy mad a wind generator out of bandsaw blades stretched horizontally
with a magnet placed 1/4 the length out that passed through a coil when the wind blows.
This is a physical representation of the principal. Like the rope experiment.
The singing bowls of India
Or a digereedoo
Old pipe organs
Blow wind across a resonant chamber in front of a tuning fork
It will cause the fork to resonate, as will a metronome tuned to
a resonant node of the fork operating nearby.


The physics are exactly the same

[Toolofcortex]

The wire core alloy should be wound with double wire or twisted pair wire then cut and attached. But now I worry about, parasitic capacitance that will make my waveguide a leaky waveguide.

So how long should the wire core be? Diameter is irrelevant.

At What submultiple of the schumann wavelenght should the wire be cut?

In electrical terms, not sound.

The goal is to reduce inductance and maximize impulse power transfer on nodes that shoot into space.

[kajunbee]

The video quality is poor as usual so not much can be seen.https://youtu.be/tPuhI03ZMR8

[Toolofcortex]

Where does he open it?

[kajunbee]

I only saw him cut section open around 4:45. I just fast forwarded to that point.