Lords of the Ring

[Victor]

Hello Everyone,

I know, my words have no the touch with the subject.
See the movie The Prestige

Yes giantkiller, well saied
Tesla is alive and kicking in the TPU!

Best regards to all
Victor

[Rosphere]

...Hell, you weren't trying to pick up chicks with it anyway, right?.

Right.  I am hoping to pick-up kicks. 

[giantkiller]

Nice coil Marco! I found the magnet coil vid. Imagine the longitudinal torsion if the upper magnet was not allowed to rise!
Also, would it be possible to point me in the direction of the big graphic you made showing the device connections of the magnetic transmission demo a few months back? I've searched it and cannot locate it. Thanks.

The similarities of all the best device tests seem to point to 90 degree alignment of 30awg or small awg wire. The IDE cable gives very good small gauge accessablilty and the ends can be tied in parallel to get the current out while working within the thermal properties of the wire. Shades of Tesla. The small gauge also gives a higher amount of flux lines which, when interacting with like number of fields from an adjacent 90 degree set, will produce the maximum amount of interactions. The electon stress, which is what we are striving for, is not overpowered by a huge magnetic alignment. That electron stress, which produces very high frequencies, emits the radiant energy.

The safe clue that was given was 'lamp wire'. Small gauge.

The Tesla 382282 transformer shows the 3 concentric layers starting with the core gauge inside, the next layer out with a very small guage at 90 degree placment, the outer most layer of a larger gauge.

--giantkiller.

[Rosphere]

...I found the magnet coil vid....

That video gives me a delicious off-topic idea.   

...The Tesla 382282 transformer...

Hey, that's that transformer shown in 390721! 

[turbo]

hi all

@turbo

is that a harddrive cable in the middle of that tpu

wer

old 1,44 floppy disk cable i believe it has 32 leads.

@Jason here is the pic.

"Most of the more successful units we made had control wiring run or wrapped vertically over the horizontal collector wires.  You can see them in the units in some of the videos under black plastic covering.  They were run perpendicular to the travel of the collector wires.
They were run in multiple segments.  Each segment could be fed a different frequency individually and or from a collector section to help perpetuate the oscillation and control."