Lords of the Ring

[otto]

Hello all,

over a year long I thought Im working with a group of nice people that wants a TPU. Now I see Im working with a group of nice people that DONT want a TPU.

Its your fault, not mine!!!

@Jason

have you connected one end of the collector to the pulses too, if not so do it.

Otto

[innovation_station]

.

[d3adp00l]

well I would like to thank Mr. Mark for what seems to be a great discovery. However I am a little irritated that he sold out. And now leaves the rest of the world to try and rediscover what he did. So now more time is killed. I hope the people on this site keep up the R&D, and hope that they are able to figure it out. Its as if Tesla created A/C showed it to us, and then shelved the design saying "well I sold it to someone who isn't releasing it, what can I do? use dc until you can figure it out"

[Dansway]

@d3adp00l

That may be true, but we will figure this out. 

I for one, am grateful to Mr. Mark for coming forward to give us the clues.  Mr. Mark did not have to do that.  Thanks again Mr. Mark!  ....and to you too Lindsay.

The TPU is a simple little critter, but must be tuned and there are several ways to build it.

Yes, it would be great if Steven Mark held a conference somewhere and taught 'exactly' how to build this device, but  that is not going to happen.

So we continue down this road...

~Dan

[otto]

Hello all,
@IS

you have copper wire? Wind a 50 turn coil over your 2 fingers.

Connect 1 end to +12V, the other end of this coil + (plus) 1 end of your collector to the pulses.
The collector should be a litz wire, or lamp wire. It dont need to be a ring. The lenght of this "collector" is not important. This "collector" needs to be insulated because its going through the control coil. See what happens. Puls the 50 turns wire with 1 then 2 and then 3 frequencies. What happens??? Of course you have to connect a 24V/5W bulb as in the picture. If you dont want the other end of the bulb connected to a minus then connect it to the + from the power supply, its the same.

This all canbe done in a few minutes. Please tell us what you see. Then we will make the next step.

I also dont want to mislead the guys and that was the reason I didnt post a long time about my work. So far you did a great job with the TPU.

Otto