Holcomb Energy Systems:Breakthrough technology to the world

[Cadman]

Build a hand/foot operated magneto into the LinGen. Like an old fashioned dynamite detonator.

[SolarLab]

Should clarify a bit more - the controller/driver card is a pcb that runs along the clean ends
(no windings are in the way) of the rotor-stator plates. Dimensions of the two plates are
approximately 3.2" [+ pcb-SM] x 5.2" x 1" plus coil overun. These units can be stacked or linear,
as required.

The top and bottom of the rotor-stator plates are flat and clear (hint - capacitor/inductor/electrostatic???).
{unroll an electrolytic - back emf - etc. still thinking...}

Cadman - good idea, thanks - but might be too expensive and bulky for a one-time use. LinGen material
cost is about $15 US; magneto would be, maybe, $20 plus case and labour.

[bistander]

Why was it turned off?

If it runs autonomously, start it at the time of manufacture and it runs forever. Or am I missing something?
bi

[SolarLab]

Why was it turned off?

If it runs autonomously, start it at the time of manufacture and it runs forever. Or am I missing something?
bi

Read the examples then think about it a bit more.

Shipping (a live device - a definite no no). Storage, again a no no.
Maintenance - troubleshoot or fix a "hot device" - not me. Initialization - on and on?

Ideas are welcome, not stupid, out of the ass stuff...

SL

[sm0ky2]

Its not an energy or power gain.


The original patent only steps the voltage, not the current.
Current is lowered, resulting in slightly less total power out than in.