Capacitor Electrons Captor from Don Smith / Tesla

[Vortex 22]

Here ya go:
https://i.postimg.cc/c4XFnVXY/Primarycapsdiodes.jpg

See you tomorrow in about 23 hours.

Hello,
Are you referring to Don tabletop device photo?
Pulse cap and coil? That's not open circuit? If not then you know the reality of induction magnetic loses?

[Vortex 22]

Hi,
I have try the same setup but using two different input ( open circuit) and guess what?...

[madddann]

Hi, I posted that photo because you were guessing if caps were in series or in parallel. Well, there is no guess work needed it is obvious from the photos ( I'm posting previous photo again - had to remove it from that link):

https://i.postimg.cc/2yhQFdVL/Primarycapsdiodes.jpg
https://i.postimg.cc/zB9wg2X1/don1.jpg

...but it is also true that Don said that this is not a working device and was put together just to see how the components would fit on the board.

About speeding up the charging, common sense tells me to up the voltage and frequency until managable limit, building one stage after another is also an option.

You would prefer smaller polar caps? What kind of polar caps - what voltage and uF, I think there is a reason Don made it the way it is.

[am1ll3r]

Simple experiment complete. Similar results.
Cheers!

[Vortex 22]

Hi, I posted that photo because you were guessing if caps were in series or in parallel. Well, there is no guess work needed it is obvious from the photos ( I'm posting previous photo again - had to remove it from that link):

https://i.postimg.cc/2yhQFdVL/Primarycapsdiodes.jpg
https://i.postimg.cc/zB9wg2X1/don1.jpg

...but it is also true that Don said that this is not a working device and was put together just to see how the components would fit on the board.

About speeding up the charging, common sense tells me to up the voltage and frequency until managable limit, building one stage after another is also an option.

You would prefer smaller polar caps? What kind of polar caps - what voltage and uF, I think there is a reason Don made it the way it is.

Ok
Well, the basic idea is to charge a Cap from ground ( not from battery) and discharge it into one turn of primary coils ( Tesla coils)
On the secondary Coil the voltage and frequency is up to charge a capacitor bank?

Take care