New accelerating gravity wheel ! Converted video from www.newenergymachine.com !

[Charlie_V]

I'd like to add:

www.emovendo.net  (magnets)

www.sdp-si.com (bearings and shafts)

Both of these websites are good and have typically lower prices.  K&Jmagnetics has more selection of magnets but they are generally only N42 and more expensive than emovendo (which only sells N48's and at a better cost bargin). 

[4Tesla]

Thanks!

Edit:

This is a great place to get Clear PVC Pipe by the foot! (very hard to find)

Aquatic
http://www.aquaticeco.com/subcategories/2480/Clear-PVC-Pipe

[4Tesla]

I guess Jason has been busy. I hope that's a good sign. I've downloaded Phun and have been playing around with that. Not a very extensive help file so I've been feeling my way around. In Phun, I've got my design to go around up to 7 times and with a little more tweaking I hope I can keep it going.
Larry, how are you coming?
Regards,
Charlie

PS....Kudo's to Stefan for buying more bandwidth or employing some other magic because it seems that I can access the forum much easier!

Can you save simulations with Phun or make movies with it?  If so could you post your simulation?  What are you using to make your drawings? - Thanks, Jason

I think Stefan just has a temporary fix for the site.. he still plans on moving it to a better host when he gets back from vacation.

Jason

[LarryC]

Larry, how are you coming?
PS....Kudo's to Stefan for buying more bandwidth or employing some other magic because it seems that I can access the forum much easier!

First I would also like to thank Stefan for his efforts, I'm sure it was a lot harder than most of us realize.

I picked up the new door knob latches this pass weekend. I am halfway thru getting them installed. I have the main body, slides, weight boxes, levers, and main spindle working. Also, as I'm sure this will be a tweak fest, I will be using bungee cords instead of springs during the test phase. They should be easier to adjust and modify than springs. So maybe by Friday I'll have some info to report.

I am really looking forward to testing how much addition force is required to move the weights to the midpoint + 1".

Thanks, Jason and Charlie for the cad update. This may end up being more important than our physical testing.

@Jason and Charlie_V
Thanks for the additional resources.

@ alaskabobb
Welcome, Great that you are trying knew designs, but your drawing has me confused.

Regards, Larry

[noonespecial]

Thanks, Jason and Charlie for the cad update. This may end up being more important than our physical testing.

I just tried to load a Phun file for you guys but apparently you can't upload a .phn extension. I would strongly suggest using one of these modeling program to save a lot of trial and error. Unfortunately there is no 'save as' so I can't show you what I've done in another format.

Looking forward to your update Larry!
Best,
Charlie