Successful TPU-ECD replication !

[ronotte]

@Darren,

the pin numbers on my diagram are correct. You can check-it on IR 7307 Application attached. Of course remember that you can drive the 7307 with +12V without any problems (on past I used only the +6V for safety purposes...but it doesn't need).

Best luck for your work!

@GK,

thanks for assembling my speech!  ...are you ready for firing your Mobius?

[ronotte]

...sorry here's the attachement

[z_p_e]

@Darren,

the pin numbers on my diagram are correct. You can check-it on IR 7307 Application attached. Of course remember that you can drive the 7307 with +12V without any problems (on past I used only the +6V for safety purposes...but it doesn't need).

Best luck for your work!

@GK,

thanks for assembling my speech!  ...are you ready for firing your Mobius?

Roberto,

Thanks for the app note.

I see the problem now....the error is in their application note.

They have the N-channel and P-channel devices connected opposite. The P-channel needs to be at +V, and the N-channel at gnd.

I'll email IR and let them know.

Thanks,
Darren

[giantkiller]

@Darren,

the pin numbers on my diagram are correct. You can check-it on IR 7307 Application attached. Of course remember that you can drive the 7307 with +12V without any problems (on past I used only the +6V for safety purposes...but it doesn't need).

Best luck for your work!

@GK,

thanks for assembling my speech!  ...are you ready for firing your Mobius?

I have TC4427's on the way. They are faster fet drivers.

--giantkiller.

[nong]

This is for high speed mosfet here.