Stanley Meyer replication with low input power

[TheNOP]

precursers to H2O

so, if i understand correctly.
you are saying that the ozone accelerate water dissociation, acting as a replacement of the amps.
right ?


@all
see this, good reading.
http://www.lsbu.ac.uk/water/magnetic.html

[Grumpy]

so, if i understand correctly.
you are saying that the ozone accelerate water dissociation, acting as a replacement of the amps.
right ?


@all
see this, good reading.
http://www.lsbu.ac.uk/water/magnetic.html

No. 

Meyer broke down water/steam/air into constituents that possess a great amount of potential energy over a long period of time.   He then converted this potential energy into kinetic energy in a very short amount of time.   

Sort of a molecular spark-gap transmitter like Tesla often used and rported obtaining millions of horsepower out with only a few horsepower in.  Energy is conserved - power is not - and power is what runs the engine.

[WFC-Greenhorn]

Hello, i am new here and i need some help. Here is my WFC : http://www.youtube.com/watch?v=bcNuTvo_I-E
I have the problem that i have big bubbles, but the time between the bubbles is to big. Can somebody help me ?

[lefferdink]

If no one else wants to help you out I'll give it a try.  Nice looking cell. If you have a pwm hooked up to your cell and the clearance between your tubes is about .064 and .045 thousandths of an inch, you are on the right track. You have to  condition your stainless steel tubes via Ravi's method. Go to panacea university.org (on the internet) and scroll down to Ravi's water fuel cell replication. The process is listed in this document.
Cheers, Ray.

[WFC-Greenhorn]

Thank you very much for your answer. First i tried it like ravi has it done, but i hade no real succes. Then i disassambled the whole WFC, cleaned the tubes and build it up new with only 2 tubes. Fist what i recogniced is that ther was no more brown junk. I wanted to follow ravis method of conditioning, but i never reached 2.5 or 3 amps, so i decided to condition the tubes for a few secends with max amp and then with only 0.2 or 0.3 for 30 minutes and the after this for a few sec max power again and then power off. HHO is still increasing, but am i on the right way ? Or do i have to modify the PWM for higer frequency ?
Thanks for every help !