Stanley Meyer replication with low input power

[ashtweth_nihilisti]

J, the tubes are listed in the Doc 316L, plus we need ot fix a few things on that Schemo, so don't use the wiring diagram yet guys, Sorry wont be long.

Ash

[Jamie]

I just wanted to know what the leads were, not the tubes. I know they aren't 316L

They also have ferrite rods, which one of these would be the best https://www.amidoncorp.com/categories/6?

Matt since no seems to know which one to use, I dug up this chart:
https://www.amidoncorp.com/specs/2-02.PDF
Now we have three choices, 33, 61, 71. These come in 3/8" It appears the higher numbers are for higher frequencies. Someone said Dave was running his cell at 5714Hz and 33 ferrite material is good for 1 KHz to 1 MHz, everything else seems to be in the Mega Hertz range so I think I'm going with 33.

[ashtweth_nihilisti]

J, sorry about that, yeah the leads were 316, Ravi advises to use Copper and silicon, its in the Doc

[Jamie]

@ Ash

Oh I see now, thanks for the clarification. Then what drill and tap for the copper I guess? I don't like the thought of drilling the tubes much though. Maybe I could silicone them right on  , but I don't think that will be good contact. I'll look in to this.

[mostrander]

Jamie,
Thats what I was looking at using the 33 rods for the inductors and the J Material Ferrite Toroids for the transformer.