Stanley Meyer replication with low input power

[insane4evr]

@xbox,

Thanks for the links.

Did you notice any difference between the conditioned and non-conditioned plated during gas production?

As much as I can remember, non-conditioned plates had fewer but bigger bubbles and were enough to overcome the 2 inch water head inside the bubbler.

The conditioned plates create lots of microbubbles but only a few could break thru the surface tension of the water inside the cell. So not too many bubbles on top of the water inside the cell and nothing came out of the bubbler. The microbubbles look like a cloud in the water and just circulate in the water of the cell.

[bxngoc]

I checked new messages from forums and yahoo groups before go to the bed and found a good news
Daniel Dingel water car secret revealed!
http://eurobier.com/wasserauto/Dingle.htm

Can't read german but Google will does translate task.

Too excited and can't sleep tonight.

[forest]

This is the same as Stanley Meyer Water fuel cell 

This is the same as Nikola Tesla "extra coils" setup 

This is nothing new...

[kinesisfilms]

"@Jamie:
What size toroidal did ya use? Wannna make me one...lol  "
I used FT-290-J from amidon. It's the J material. https://www.amidoncorp.com/items/21. Yeah it's a pain doing 600 turns of 36 gauge. It took me about 2 hrs not including making the needle thing for winding. And it's 23 ohms of resistance  . The core is big. Almost 3" in diameter. I think they sent the wrong one. I also ordered 3/8" ferrite rod and they sent 1/2".  what can ya do? I'm gonna go hook up the scope I will have a shot in a couple hours.

let me know how it comes out...i have the exact core dimensions from his patent with the 24 guauge and 36 gauge copper wire....im going to start winding tonight and tomorrow....i would like to see how it comes out on the oscope.

[Jamie]

Sorry it took so long to post. I've had a pile of work.
I can't seem to make any sense of my scope shots, maybe it makes sense to someone else. In any case I made a video so you guys can see what I'm seeing.

PWM + MOSFET - PWM sits in the carboard box. The MOSFET is just outside the box.

Transformer - The transformer is made to the specs in Ravi's document. The coils on the transformer
                    are wound in opposite direction to eachother.

Cell - I built a little cell out of some stainless muffin tins that I cut the bottom out of and put spacers
        in between them.

I'm getting around 250 V spikes on the primary side and about 55 V spikes on the secondary side when I hook up the transformer. It doesn't make sense to me. The transformer destroys the wave form on the primary side. Here's the video: http://www.youtube.com/watch?v=-MeeaeP90Pw I think something is wrong.