Giantkiller moves forward into Full Heterodyning.

[Feynman]

And when the smoke curl climbed from the fet into the air and the protoboard melted, well, I was asked if I needed a fire extinguisher.

Haha, fantastic.  That's quote of the week.

What driver circuits are you using for the 32hz frequency?  I mean the oscillators rather than MOSFETs.  I take it these are not the Linear Technology chips... 

[altium]

Hello, GK.
Sorry my question if already answered (my search return no results).

First, I am wondering what type of magnets do you use (neodym, ferrite)?

Second, In which point you have connected the load.

Thank you!

[MACEDONIA CD]

hi
gk @   you are  rong everthing  THING  you see my video  again  how is posible you to   make  whit mafnet to increase the v   and a 
HI ALTIUM    I WAIT NG  YOU   

[sparks]

    @GK

    I gotta name to advance for you new design.  Pingpong tpu.  T is not for torroid but terrestrial.

   I just did an experiment again to verify the catalytic properties of a kick.  I wrapped some copper magnet wire around a fluorescent bulb and put it to the output of a 4watt cb radio.  Then I pulsed the heater filament with 12volt while keying the mike with a rubber band.  The  40watt bulb lit not totally but at least 25percent.  If I talked into the mike you could see it on the bulb output.
You could also hear me speaking on my son's guitar amplifier upstairs (which was immediatelly reported with a degree of outrage) and my crystal radio receiver buzzed like a bumble bee.  I imagine any cb radio user on channel 16 could hear me and the bulb also.  Just 4watts making a billion trillion molecules jump around.


      You can spin the aether,  slap it,  blow a smoke ring through it,  compress it,
Energy will displace it.  To get free energy though you are going to have to move the aether about a form of matter that will convert some of it's mass into energy then allow the ambient electro-magnetic field to restore the mass of the matter.
   

[giantkiller]

@Feynman,
I used a 555 to irf840. The idea was to get this test up and running.

@Mac CD,
I scrounged up stuff laying around to reproduce the Leedskalnin PMH.
I got results. When the iron saturates the current draw goes higher than 10amps. This happens within 3 seconds. This ramp up period seems to coincide with the time SM waits.
I tried to get your video but there were download problems.

@altium,
Cabinet magnets. Just like SM showed. I have 200 of them from the David Hamel experiments of the 3 layer steel drum project.
The coil is connected between ground and the fet which is connected to positive.

--giantkiller. Pretty simple here.