Giantkiller moves forward into Full Heterodyning.

[sparks]

@   Buzzard

    I suggest two of your coils are better than one.   The coil you have built is pulsed to get a rotating magnetic field.  Fine and dandy but you have nothing for the rotating magnetic field to work on.  SM always has a two ring build.  One to generate the rotating magnetic field and the other to convert the rotating magnetic field to dc pulsed output.  The space in between the two rings determines the output wave.  If the top ring is just catching the magnetic field shift generated by the lower ring you get a choppier output wave form.  Like in all dynamos or alternators.  You have the magnetic field disrupter (in the case of the automotive alternator this would be the magnetically polarized rotor) and the observer of this disruption the collector
(in the case of the automotive alternator this would be the stator).   The significant difference between the tpu is that the magnetic disruption is catalyzed by an energy spike.  Therefore there is no mechanical drag down like in an automotive alternator.  No counteremf just all forward emf.

[innovation_station]

not the good old positive feed back loop eh?


good stuff guys i took a wee brake from the tpu as i now have tooo much to play with... to play lol

gotta love yard sale season.... 

ist

[buzz-ard]

@Sparks - thanks for this. Many things are starting to congeal in my mind over the last 3-4 days, and I haven't been able to devote the bench time needed to keep up with the new thinking. Mom always gets priority, you know.

[giantkiller]

What I see is the Tao graphic but with lables now. The bifilar are the control windings of copper and the outside windings and the inside ring are iron.
Telsa, Leedskalnin, SM all mentioned iron. Now I am not shooting the posters down but the facts stand for themselves. These heroes got it. Anyone of us can make a step farther than the rest by instituting what any of these 3 giants among men have done. Simple as that.

I been trying to come up with a jig to wind the horizontal iron winding to maintain a cross-sectional squareness. Using PVC I think I have what I need.

But now I will go back to the PMH design I came up with. I was trying to figure out how the scope signature of the rising and falling ringing between the positive pulses occurred. I will test by removing the long sections off iron bars from the ring loop. To see what part of the signal disappears or gains. This sets up the results of the what Tesla had his windings edge to edge so magnetic flux cannot escape or leak out.

I don't know how to test with the stun guns without bringing down the house or other equipment or without scaring the dogs.

Depending on the results or not I will strip one of the steel/copper coils and wrap a curved iron section fully. This creates a winding that is 3 deep using 1 frequency instead of 3 coils with 3 frequencies.

The 2 layer SM coils look like ionizer plates. That would essentially be spreading out the spark gap to a wider plane of conductance instead of a single point of conductance. Safer.

I don't like the feeling of RE on the body anymore. Be careful.

--giantkiller. What looks like fun can turn the mystery into a nightmare.

[ramset]

WHOLLY   OUCH  GK   although  I  bet he was having a good time     Till later   [understood]    Chet