The IST's 15" TPU Project~~{The SM15}~~

[innovation_station]

so i wound some of those up there many many ways to wind these and many ratios so I'm sure they are just not right yet but they are easy to install and change in the 15" tpu to find the right match this is like a pickup in a guitar but for magnetic waves as well it mixes all of the freq and resends it back into the loop here is a pic of some of my balms i have built so Far

ist

[innovation_station]

in this picture you can see i added a fuse in the collector i hooked up the balm it is wound with 28 GA solid wire bifuller in 3 segments of 10 turns oppsite direction to the controls then it goes into my 2 groups of 3 block connectors then in to the control's you also see an input block connector to the balm and a collector block connector this collector block connector is hooked up to a cap

the cap value in my pic is 50v .1 uf  it is a nonpolized  cap and this closes the collector loop

ist

[innovation_station]

now I'm sure all i have said so far is not all correct but it is the best that i currently understand it

in this next picture you see i hooked up a diode and an output CAP to the block connector

this is where I'm at now

i also added a resistor and output leads to the power cap

i have not tyred any power to this unit yet

ist

[innovation_station]

 

this is where it sits and before i can even try this out i must build an amp or find at least 1 3 will be much better with 3 amps i can bang each coil separately or with 1 amp i can bang them all at once 

so guess what mannix?

tubes lol!!

[hartiberlin]

Hissy, are you just here to post this drivel ?

Please stop this.