Selfrunning cold electricity circuit from Dr.Stiffler

[gotoluc]

Hi Dr. Stiffler,

today I received the tuning coil that you sent me in the mail for free, thank you. It is now on the board and all is working well.

Thank you also for continuing the research on your new site and the access to questions.

Luc

[samedsoft]

The new site is far from complete, but it will show that I have not hidden and the MIB's have not got to me.
Thanks....

@Dear Doctor,

     I would like to thank you for your new site and letting whole world to access SEC theory in a more formal way. SEC14-1G1 Prototype apperently shows the COIL configuration has very important affect on the Energy conversion process.

     I have been thinking for long time and please correct me if below ideas  are  not relevant;

      1. Parasitic plate may be any conductor and different antenna configurations might be designed for optimum surface coupling and energy pumping.

      2. Coil must be copper  because of  Copper's unsolved properties yet?
   
      3. Example 40 may be furher expanded in a similar way to achieve higher voltages?

    Could you please also label and value the SEC II design schema?
     
   Looking forward for your comments and new you tubes..

   Best Regrads from
   Nuri Temurlenk Istanbul   

[Loki67671]

@All,
I'm going for the heat runs.  A sneak peek for you.  Do you think it's hot? I hope my calorimeter works as planned. Just about 36 mW's over 1 watt input in these pictures. Soon! Anyone else discoloring neon's and beating transistors? 

Best regards,

Jim

[forest]

Please confirm if this is normal.I've taken a digital photo of my SEC replication with neon lit in orange but on photo it is very bright white light ! Is that because of not visible for human eyes radiation (UV,infrared?) ?

Second observation : burn from SEC is really painful ,be careful! First there is small itching but after that I felt a pain in full hand and stiff muscles.

Last observation : I used common transistor BC639 and it seems to work as well.

forest

[Loki67671]

Please confirm if this is normal.I've taken a digital photo of my SEC replication with neon lit in orange but on photo it is very bright white light ! Is that because of not visible for human eyes radiation (UV,infrared?) ?

I would not necessarily jump to that conclusion but it is possible. May just as likely be the CCD imager in the camera driven to saturation. Could be both! Loki

Second observation : burn from SEC is really painful ,be careful! First there is small itching but after that I felt a pain in full hand and stiff muscles.

RF burns tend to be this way. I have suffered quite a few myself. Yes I get pain stiffness later on also but nothing that I would say is out of the ordinary. It is the nature of an RF burn. I've had them from working with High Power radio gear mostly from transmission lines.  Loki

Last observation : I used common transistor BC639 and it seems to work as well.

Define "as well"  Dr. Stiffler shipped his SEC15-3 with MPSA06's that he graded for high gain, hfe about 250, try to stay in that range. The higher gain transistors I use the better my results are. Just a little observation. Try high gain MPSA06 or equivalent. Loki

forest

@forest
See my answers above and watch the RF burns.  Keep at it.

Best regards,

Jim