Nathan Stubblefield Earth battery/Self Generating Induction Coil Replications

[jeanna]

Here is something you all may want to try. I found that flat metal works better then the round metal for the post. Out of 15 cups I used, I got almost 4 more volts using frat metal insted of round metal.

4 volts!
wow
How did you set this up?
15 cups? do you mean you are doing a cement pot type of thing?
I have a couple of flat pieces of steel I could try. I have an Aluminum can I could fill with earth and try. 4 volts!
jeanna

[nightlife]

jeanna, that is was the difference I got from using water in cups. It may help with what you all are doing using the earth.

[jeanna]

@ Jenna

i mean from the electrodes in the ground  to a super cap or other cap and off those leads to where the input from the battery would normally go on the circuit.  Hope that helps
                                                                                                                                 Joe

Yup. It does.
I may want to solder  a new cap arrangement.
thanks Joe,
jeanna

[jeanna]

OK a new little report.
Still no light though.
I changed the fuse in my voltmeter. (thanks, Freezer)

Cu pipe to mg block
1.35vdc, 2.3 vac, 0.038A

C₄ rods to mg block
1.27 vdc,  1.8 vac,  0.016A

C _{filter granules} to mg block
1.4 vdc, -.8 vac 0.035A

I jabbed the + end of the jule thief mit light into the carbon granules and clipped the other side to the clip that goes to the mag block. NOPE.

It's 2PM here now, (10 PM in Germany) I still have another hour. and it is sunny any things I forgot?

jeanna

[Localjoe]

We need to have bill try this he's the only one with enough current to use this probably. Good work jenna, ps did you have the cap in line with your electrodes powering the thief?
                                                           Joe