Some thoughts on how the TPU might work.

[Localjoe]

Sounds like I_S has heard some gossip again.

He is correct that a spark gap is not required, nor are mosfets, or tubes, etc. - not that these would not work as they may.

Precision is required, however.

See its funny IS couldn't even tell me the inductance rating on a few of his coils he had built and i asked him if he had a cap tester or lc meter or if he could find something to measure the milli henry value and he told me that he had a little selection on his meter labeled ma.. i replied thats milli amps....He did not know what reading i was talking about and once i explained it hes insisted it didn't matter... Funny! How else would you make a piece of wire tuned to a resonate freq of an iron core without cutting the length, measuring inductance and then testing for resonate freq? I mean after reading what sm went through cutting the wire little by little you think he might have written down the wire gauge  length and inductance rating so when he got it right he could do it again without guessing....

[innovation_station]

i know i am damm right


doubt it  if you must

i have removed my doubt

ist

@ grumpy of course all of the above mentined things will work but agin none of them are required 

if some one knows what i am speeking of speek up

if not i guess you know what you must do

[sparks]

    I am going to try to buid a tpu that uses no kicker windings.  I experimented with these windings and what they do is setup a longitudanal electric field wave.  So they initiate current in the attractor winding.  By timing the pulses you start to get resonating energy release into the ring.  It is just like a kid paddling water on the outside of an above ground pool.  Pretty soon the water is going around and around like crazy from just introducing a little bit of energy at the right time.  Mystical wave properties?  Golden mean wave interference?  No,  just an electrical current in a closed loop conductor,  this current built up by supplying and storing small amounts of energy.   The real deal is when you look at what you have when there is an electric current in a ring conductor with no metal around it.  Below is a picture of how a magnetic field would build up around a ringed conductor.  This field would build-up with just pure DC supplied to initiate the attractor current.  When ambient energy waves encounter the magnetic field around the tpu one of two things happen.  First they could be guided by the mag shell to the inside of the tpu winding where they bend the magnetic lines of force enough to let their energy into the ring current.  Or they react with the mag shell enough to distort it's field strength.  Now what you have is a conductor (attractor winding) lying within a changing magnetic field,  which always seems to result in an electrical current flow.  There is a distortion of the magnetic field near the conductor.  This is pretty much what happens when a prime mover moves a permanent magnet through the magnetic field around the output windings in an alternator.  Or a primary winding changes the magnetic field in a transformer core around which the secondary winding is wrapped.   CHANGE THE MAGNETIC  LINES OF FORCE NEAR A CONDUCTOR - GET ELECTRICITY TO FLOW   This is a very simple explanation of the TPU working dynamics but it is the best I have to offer.

[Evil Roy Slade]

There seems to be a significant amount of work going into Steven Mark TPU devices. Since
I know nothing about this dude I would be grateful for some information.


Who is Steven Mark?
Where is he?
Does he post here under another name?

ERS

[Grumpy]

i know i am damm right

doubt it  if you must

i have removed my doubt

ist

@ grumpy of course all of the above mentined things will work but agin none of them are required 

if some one knows what i am speeking of speek up

if not i guess you know what you must do

Why should anyone speak up?

...
Who is Steven Mark?
Where is he?
Does he post here under another name?

ERS

The answers to these questions are not important.