Muller Dynamo

[redrichie]

Question on the halls positions if it hasnt been covered.  If it has just point me to the page.  But ive been watching the generator with extra magnets video over and over again.  And of course it will be the same for the other vids as well.
     One hall is on the periphery of the disk with a very short pulse width.  the other is on top of the large rotor magnet.  This will make a long pulse.  And it would also depend on the angle of the dwell of the disk.  OR the ark of the circular magnet if some are not familiar with the large bedini motor that used halls for triggering. IT seems like the large magnets hall is switched on and right as it ends or right before it ends (very important to distinguish I feel) the other smaller pulse is fired.   Is this to cancel the Lenz that is about to occur in the first drive pulse. and then the generator magnets finish off the lenz from the second smaller pulse as they are now driven into position to break free from their magnetic lock? 
    ring twice?

[ZeroFossilFuel]

Question on the halls positions if it hasnt been covered.  If it has just point me to the page.  But ive been watching the generator with extra magnets video over and over again.  And of course it will be the same for the other vids as well.
     One hall is on the periphery of the disk with a very short pulse width.  the other is on top of the large rotor magnet.  This will make a long pulse.  And it would also depend on the angle of the dwell of the disk.  OR the ark of the circular magnet if some are not familiar with the large bedini motor that used halls for triggering. IT seems like the large magnets hall is switched on and right as it ends or right before it ends (very important to distinguish I feel) the other smaller pulse is fired.   Is this to cancel the Lenz that is about to occur in the first drive pulse. and then the generator magnets finish off the lenz from the second smaller pulse as they are now driven into position to break free from their magnetic lock? 
    ring twice?

I am so glad you asked that question because I was wondering the same thing! Why not trigger both hall sensors from the peripheral magnets? or both from the disk magnets?

[redrichie]

OK so this hasnt been covered?  thought i was reading too much these last couple days.  I do know R said to worry about halls last.  I just started re-reading the thread.  Even though its last I think the theory with the different pulses is important.  Also to everyone.  I would say dont give up.. R also stated he moved his coil and rotor dimensions hundreds of times. 

[toranarod]

I have been doing some test?

Remember he said a few time he would test it until the people next door complained. I think this is a very big clue.
how could a little pulse motor make so much noise? Well it can

and I believe now it is an attraction motor .

[scotty1]

hi all.
I charged up a 49k cap to 15v and discharged into a similar dc/dc converter and the led (green) took 38 secs to fully go out.
The led stays lit until there is about 1.8v in the cap, then goes out fairly quick. (i did that before i read Romero's post)
So if there was some recovery it could take longer.
I also did some tests with a coil and biasing magnet, and noticed the same as others. With the bias magnet in repulsion, and a rotor spinning, the coil (directly shorted) still felt in my hand like it was in repulsion, with little vibrations. ..with the bias magnet in attraction there was big vibrations ect ect.
Scotty.