Muller Dynamo

[Rawbush]

Thanks for the offer, rawbush. I will let you know if I really need some, but I would prefer to not deplete your stock, as getting more from the UMMC might be difficult, I assume.
When you made your cores with the resin, did you apply a magnetic field during curing, to orient the particles ? I think that's important to get good results.

Regards,

Altair

I tried but it made the magnetite push out like little fingers. Would need to make a jig and used pre measured amounts to get good repeatability.

Question on the series tuning caps: Are these special caps? I have a bunch of electrolytic caps and some small ceramic ones, but putting them in the circuit shows no change on the scope...
Peace
rawbush

[mariuscivic]

<sup>@all,

Sadly my faith in RomeroUK is gone: http://www.overunityresearch.com/index.php?action=dlattach;topic=1003.0;attach=5420

I am very disappointed that someone would go to so much effort to fake these videos. RomeroUK WHY?

However, I have not lost faith that a self running Motor can be achieved. There is only one thing that needs to be done, Lenz's Law negation. With Input recovery only small amount of power is needed to get to unity.

Is it that the Elite are paying idiots to fake devices to keep us all running down rabbit holes? Be wary all.

All the best

  Chris</sup>

^{All i can see is that those wires goes under the bottom coil}

[4Tesla]

<sup>@all,

Sadly my faith in RomeroUK is gone: http://www.overunityresearch.com/index.php?action=dlattach;topic=1003.0;attach=5420

I am very disappointed that someone would go to so much effort to fake these videos. RomeroUK WHY?

However, I have not lost faith that a self running Motor can be achieved. There is only one thing that needs to be done, Lenz's Law negation. With Input recovery only small amount of power is needed to get to unity.

Is it that the Elite are paying idiots to fake devices to keep us all running down rabbit holes? Be wary all.

All the best

  Chris</sup>

^{We have seen this a few pages back.. we are moving on.}

[e2matrix]

Hi
@ plengo
@ k4zep
@ mariuscivic
@ Scratchrobot
@ chrisC
Because my language is not English,
Can not correctly understand the "bucking coils"
Please help me confirm the picture in: A, B, C, D which are "bucking configuration"
Thanks!

On another note regarding that diagram I think it was lasersaber who said he was getting Lenz free effect by using the 'A' setup.  I don't recall if I asked him that in PM or if it's back a ways in this thread but it was validated by him and I made note of it on this exact diagram which I saved.   

[chrisC]

<sup>@all,

Sadly my faith in RomeroUK is gone: http://www.overunityresearch.com/index.php?action=dlattach;topic=1003.0;attach=5420

I am very disappointed that someone would go to so much effort to fake these videos. RomeroUK WHY?

However, I have not lost faith that a self running Motor can be achieved. There is only one thing that needs to be done, Lenz's Law negation. With Input recovery only small amount of power is needed to get to unity.

Is it that the Elite are paying idiots to fake devices to keep us all running down rabbit holes? Be wary all.

All the best

  Chris</sup>

<sup>Don't believe everything you read, especially if the author is not believable or some stupid monkey wrote it. (Reply # 76)

Follow that thread for a couple of posts before this:

http://www.overunityresearch.com/index.php?topic=1003.75

cheers
chrisC</sup>