Muller Dynamo

[romerouk]

@Gyula
Thank you Gyula for your sugestion with the DC/DC converter .
The one from Maplins is what I used and it worked just fine .
The upload is in progress but is 1.35gb file and it takes some time

[gyulasun]

Hi Romero,

you are welcome and I am very pleased for your looping success!
Later, when you have some more time, try to place some further load to the 12V output of the converter, just to see how much extra 'reserve' energy is still hidden in the setup.
I do believe that further improvements are possible, like getting rid of the diode bridge and use controlled MOSFETs as rectifiers and so on.

rgds,  Gyula

[woopy]

 

yeepee !!

video video video

thanks for sharing

good luck and take care

Laurent

[romerouk]

Hi Romero,

you are welcome and I am very pleased for your looping success!
Later, when you have some more time, try to place some further load to the 12V output of the converter, just to see how much extra 'reserve' energy is still hidden in the setup.
I do believe that further improvements are possible, like getting rid of the diode bridge and use controlled MOSFETs as rectifiers and so on.

rgds,  Gyula

At one time durring the test I have added the 20w bulb too and it worked. The voltage dropped a little under 12 volts.You will understand more when u watch the video.Before recording the video I tried with a 20w bulb plus a 5w bulb and that was a bit too much, the voltage dropped to 10.1v .The converter is not that strong too.A better setup with bigger magnets and bigger coils will do better.That is the next step now.

[gauschor]

It WORKSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSS !

Omg, this will be amazing!! Can't wait for it!

I'm quoting woopy's post to express my feelings:

yeepee !!

video video video