Muller Dynamo

[Dave45]

Would a magnetic vortex be created?
The coils would be in that vortex path.
Hmmmmmmm
very interesting.

[Dave45]

The rotors could have all the magnets installed say six magnets on the rotors seven coils on the stators then each could be twisted along the shaft to create the spiraled vortex.
If enough stators and rotors were installed along the shaft cogging would be eliminated completely, yet each coil would catch the full impact of the passing magnet.
Something to think about.

dave

[Dave45]

You could have six magnets on the rotor six coils on the stators and offset each along the shaft
When any magnet rotor and stator were aligned there would be others that were leading away, cogging would be eliminated.
I may build a wind turbine and twist it a little 
fun pun

dave

[Dave45]

eliminate cogging

[T-1000]

Hi,

The 8/9 combination is most close for cogging elimination (the balancing of magnetic forces) and also I took that Muller arrangement to my design:
http://overunity.com/15083/the-new-generator-no-effect-counter-b-emf-part-2-selfrunning/msg426062/#msg426062
That setup was built and is being tested, no drag from Lenz and the rotor can be turned by hand easily so far..

Cheers!