Muller Dynamo

[romerouk]

Hi RomeroUK

Were you successful in running the device overnight? Last time you said it ran 'looped' for 3.5 hrs. but was trying to run it longer until the neighbors complain? Can you update us please? Thanks.

cheers
chrisC

I had it running almost 5.5 hours without complaints from the neighbours

[poynt99]

I had it running almost 5.5 hours without complaints from the neighbours

That's great news Romero.

How much load (presumably a bulb) did you have on it during this time?

.99

[gauschor]

Ah I still got a question about the 2 Hall sensors (I didn't find the exact info the previous pages):

First of all I assume that the 8 small magnets (the ones pointing outwards on the side of the rotor) are in line with the 8 larger magnets. Is this correct?

Then the final question is: at which positions are the 2 Hall sensors placed: are both hall sensors just placed "before" each one of the driver coils? With "before" I mean in rotation direction before the driver coil)

[romerouk]

That's great news Romero.

How much load (presumably a bulb) did you have on it during this time?

.99

I had only a 5w bulb as with the 20w bulb the dc converter gets hot after some time.
I tried to add the bulb before the dc convertor but there is more than 12 volts and the bulb will not last.
This DC converter is max 3amp but I am very happy about it plus the price was very low. Nice device and I think that all people should have one, it helps a lot in any other builds where people are trying self looping.I has even load protection and thermal protection too.I have tried for a second a 50w bulb as load and it switched off imediately.

[toranarod]

Hi All,
I compiled a PDF file with all the important informations and graphics:

http://www.overunity.com/index.php?action=downloads;sa=view;down=469

Regards, Stefan.

nice work on the pdf the more this is documented the harder it will be to cover it up. They will try if history is anything to go by.