Muller Dynamo

[lanenal]

Wow, just got in from work and had to catch up a lot.  Excellent work here everyone.

I submit that Romero has made enough changes and improvements to the Muller device that it is now essentially a new device.  I mean, a car is still a car but there is a big difference between a Model T and a 2011 Corvette.  (Romero's device being the Corvette)

This is astounding work here and exciting times.

Bill

Surely this design of RomeroUK is a lot more simpler to build and test...
I think we can also give a component list here. I'll start by:

1. 1 rotor plate and 2 stator plates.

2. 8 + 2 X 9 = 26 neomagnets, 20mm dia, 10mm thick, N38 rating.

3. 2 X 9 = 18 ( coils + ferrite rods + soft iron washers)

4. circuit components...

You are welcome to make corrections or add more details.

[lanenal]

Surely this design of RomeroUK is a lot more simpler to build and test...
I think we can also give a component list here. I'll start by:

1. 1 rotor plate and 2 stator plates.

2. 8 + 2 X 9 = 26 neomagnets, 20mm dia, 10mm thick, N38 rating.

3. 2 X 9 = 18 ( coils + ferrite rods + soft iron washers)

4. circuit components...

You are welcome to make corrections or add more details.

I'm not sure of the total # of neomagnets...the picture of
romerouk's build shows that not all coils have neomagnets.

[romerouk]

Below is a picture with the scope connected at the AC point before bridge.

Answer: I run out of neo magnets. I am sure that more magnets will increase the output. I have ordered more togheter with the magnets for the new setup.

[romerouk]

I was seeing some A3144 Hall sensors on eBay from Chinese sellers.  They usually ship world wide and good prices too.  Not sure on the quality.

I bought my sensors on ebay, from China. I  bought 40, I always buy more than I need, just in case...

[romerouk]

I believe I read somewhere Romerouk used 2 kg. of that wire so I guess 4 rolls of the 500 gram wire.

I had a big reel but not used all, I am not sure how much I used.