Muller Dynamo

[yssuraxu_697]

WTF!!!!!!!!!! Wont ship to USA!!!!!! or Switzerland!!!!!!! WTF does THIS mean??

Dont worry. Once you run it thru sim and see the flux map you would not want to use such spools. It has been talked about already.

[redrichie]

@yssuraxu_697
I pm"d you again.

[Pirate88179]

Of course,
Could be used for what ever 
I have 50 of theses,
cheers,
khabe

I already have brought back my wifes sewing machine bobbin I took yesterday very secretly 

Khabe:

Hey, for $50 US your wife will never hear about it from us.  Ha ha.  This is a joke and is supposed to be funny.

Bill

[TEKTRON]

Just looking at details, I noticed at 2:54 into the FIRST video right after he had turned on the load, Output meters read about 12 VDC and 2A.

But has any one noticed the input voltage.  Just a few seconds before it was 12.57 VDC @ .92 Amps.  When he turned on the output lamp,
the voltage was 12.29 and dropping fast, input current had not changed but battery was showing as if another load was on the battery!  As I recall, RomeroUK was asked this same question by another person and there was no answer.

I in no way want this to be negative question, just something I noticed, in light of the self running, maybe does not need to be answered.

Ben K4ZEP.

We have seen this many times. for some reason the current draw goes down under load. Multiply it out. some 300 ma difference. This effect has been shown in the shorting coil thread I believe???

[lumen]

Just looking at details, I noticed at 2:54 into the FIRST video right after he had turned on the load, Output meters read about 12 VDC and 2A.

But has any one noticed the input voltage.  Just a few seconds before it was 12.57 VDC @ .92 Amps.  When he turned on the output lamp,
the voltage was 12.29 and dropping fast, input current had not changed but battery was showing as if another load was on the battery!  As I recall, RomeroUK was asked this same question by another person and there was no answer.

I in no way want this to be negative question, just something I noticed, in light of the self running, maybe does not need to be answered.

Ben K4ZEP.

Romero said there was a diode from the dynamo to keep the battery charged, adding the load reduced the output voltage enough where the battery was no longer charging so the battery voltage dropped.
Same voltage drop you would see by simply removing a battery charger from the battery.