Muller Dynamo

[nul-points]

 
in the   ROMERO-UK   self-running device,


WOULD WE BE CORRECT IN THINKING THAT THE TWO DRIVE CIRCUITS ARE EFFECTIVELY PROVIDING COIL SHORTING ACTION - OF EACH OTHER - AND WITHIN THEMSELVES?


thanks in advance
np


http://docsfreelunch.blogspot.com

[k4zep]

Hi All,

List is alive!  Just received a motor today.

Link for info is:

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=130298878958&ssPageName=STRK:MEWNX:IT

Hell of a inexpensive motor, at 13K RPM @ 12VDC, 12 watt (give or take) no load, Don't know whether to re-engineer my unit or not.  Ball Bearing Shaft end, don't know for sure on the other.

Probably stick with original design,but I feel this would make a great second unit, motor about 1.2K RPM/volt it appears but has torque out the yazoo.  Could gear down 8/1 and it would push my car or drive a humongous wheel.  Just for thought.  Fast shipping too!

Keep at it all!

Ben K4ZEP

[totoalas]

Hi Toranarod
Can you please identify the parts on the driver coil circuit on your post 1761

thanks and happy  building

totoalas

[hartiberlin]

Too bad, at the end of the show my Internet connection crashed...

So maybe somebody hacked my router or my ISP
had the nightly IP number disconnect dropping...
Had also problems to reboot my PC and then the show was already over....
Too bad...

Anyway, was fun talking to you all who joined. Good Nite !

Well the show is now archieved at:

http://www.youtube.com/watch?v=N-slq2USPC0

Too bad the other guy on the line when I spoke had a train running by
producing all this noise, or was this noise done on purpose ?

Did anyone know the other guy calling in ?

Anyway, I have installed now a completely new firmware for my router,
but there was also a bigger ISP outage yeasterday night and still today over here...

Murphy´s law always hits at the most badest time....
Well that´s live...

[hartiberlin]

Hi Toranarod,
where did you exactly take the scopeshot ?

Please post a circuit diagramm and more informations, so we can follow you.
Many thanks.

Regards, Stefan.