Muller Dynamo

[mariuscivic]

What happens to the RPM when you remove the load?

.99

rpm remains the same. no change

at 2.32 i'm removing the load

[poynt99]

rpm remains the same. no change

So no change in the RPM under the 3 different conditions:

1) LED load
2) short as load
3) Open circuit (no load)

Correct?

Congratulations.

Have you tried a heavier load to see when it does begin to decrease?

.99

[mariuscivic]

So no change in the RPM under the 3 different conditions:

1) LED load
2) short as load
3) Open circuit (no load)

Correct?

Congratulations.

Have you tried a heavier load to see when it does begin to decrease?

.99

NO changeing under those 3 conditions.

No matter what i connect, doesn't cange de rpm or the imput curret.
For now the output is low but i'll try to make it more

[Magluvin]

Good stuff Marius  How did ya do it?

=]

Mags

[plengo]

Today I modified two gen coils to use the "Tesla" pancake coil style mention by one of the members. The two ends of the 7 litz wire is simply this:

End A is soldered all the 7 wires.
End B is split into 2 groups there are each isolated from the other.

The result? no good. The output voltage is ZERO. Total resistance became the double of the original and no inductance change perceived by passing a magnet although inductance was 0.12 mh and capacitance was 0.18uf.

Fausto.