Working Magnetic Motor on you tube??

[Zendalar]

What if the stator magnets were to be made movable , for a while.

Make those movable in the way that they can move around the plate on a bigger diameter in a groove like this "("

And after this make the stator magnets loose and rotate the plate with the help of a motor and see if the stator magnets stop to a certain position in the groove that was made earlier..Lock the stator magnets and and try with this setup?

Just like the way they try to find out the best place to put subwoofer. Put the subwoofer where you sit, and find the place where it sounds best..

Just an idea, hopefully you understood what i meant

[hydrocontrol]

Since the only thing that counts is successful replication, it is looking more and more like the original device was a fake.
[/quote]

There has been enough video evidence besides Al's video to show that there is something strange going on between the rotor and the stator. Even Al had stated it took weeks of playing around and multiple stators to get it to work. And that was just by chance. It is more like the original is a fluke than a fake. Just the right combination of rotor / stator mass, distance, magnet strength..etc ... With multiple people working and dissecting what has been present and documented I feel it will eventually get figured out and maybe a better system that is easier to reproduce will be presented. Or maybe it will be determined it is a fake. With just a couple weeks out of the starting gate it really is to hard to tell and I am not ready yet to proclaim it is dead.

[canam101]

Since the only thing that counts is successful replication, it is looking more and more like the original device was a fake.

There has been enough video evidence besides Al's video to show that there is something strange going on between the rotor and the stator.
[/quote]
What? I didn't think anybody had gotten acceleration, just agw lock, which is chickenfeed, apparently.

With just a couple weeks out of the starting gate it really is to hard to tell and I am not ready yet to proclaim it is dead.

Maybe so, but I doubt it. I think it is as dead as Stiffler's amazing circuit. Dead, dead, dead.

[emitremmah]

Don't know if anyone else has noticed this but things could be misleading.
1) the little square something on the edge of the rotor to the left of the top marking.(pointed out earlier)
2) The rotor is actually made of a clear type of plastic, not white, This is demonstrated by the sticky tape put on the top makes the that area clear. Just like when you [ut clear sticky tape on a frosted window you can see clearly through it. I would say the white colouring is just a rough surface from milling or cuttin. It is not that the rotor is opaque. This may mean that the HDPE which I think is white is not what the rotor is mode of.
3) Through the clear area of the rotor yo can see the central shaft. Maybe more information can be found here also.

Just some notes while I wait to hear more from the replicatiors.

Bernard

ps. Dr. Stiffler's circuit is dead yet by far. It is also the only 'free energy' device I have seen work. Evenm though it is not in the megawatts. I would like to see you ligt 50 leds with a single wire with no energy input.

[ken_nyus]

I took two screen shots on my scope showing the relationship of the stator and rotor at the crossing of the stator while in AGW rotational lock.
Someone could maybe overlay them for a better reference.

Thanks Lumen for sharing this!