Working Magnetic Motor on you tube??

[Craigy]

the pdf is right , i got the magnet codes off of the thread and it was a time consuming business, not cubes , but as clanzer and yourself pointed out

[CLaNZeR]

I have gone for a 85mm rotor and think the magnets can be either Rod or rectangle or cubes stacked.

Would you agree with the quick measurments below before I mill this out?

Removed as was WRONG!!!!

[magpower]

Your rods look small to me, 10mm long. Looking at video they look like 3/4" long or even 1", maybe I am wrong!

wayne

[MeggerMan]

Hi,
This is a very hot project at the moment, I can see a lot of people will be replicating this.
The 8 rotor magnets look like rod type not slab and by pasteing the image into PSP and knowing the radius I have calculated the size of the rod magnets to be:
0.54" or 13.78mm length
We know the thickness is 0.25" or 6.35mm

Rods are polarised through the length.

Getting the diamagnetic polarised stator magnets is tricky on the UK , so I will need to order these from the US.

The bearings look like model RC racing car bearings, so I guess ebay would be a good source for these.

Regards
Rob

[TheOne]

CLaNZeR:

Ok I taked a good look about the size, sound like my 22" minoteur in 1600x1200 give me the exact same size from one of the photo

Here some of the dimension:

I was wrong with the rotor magnet

rotor magnet: 3/16" dia. x 1/2" thick (http://www.kjmagnetics.com/proddetail.asp?prod=D38)
outer magnet: 1/2" od x 3/16" id x 1/4" thick (same as the begining, http://kjmagnetics.com/proddetail.asp?prod=R834DIA)
rotor size: 5 1/2"
frame size: 7 1/2"