Working Magnetic Motor on you tube??

[wildgunz]

I hope someone gets a replicaction done soon,I haven't slept more than a couple hours at a time this past week.

[ken_nyus]

http://ustream.tv/channel/overunity-testing

just testing , can you connect and see if its any good? Broadcasting live from tenerife
[/quote

Works fine in IE6 for me here on the east coast US, but nothing shows up in Firefox for me.

[Grimer]

I hope someone gets a replication done soon. I haven't slept more than a couple hours at a time this past week.

Good for you mate. You've got the right attitude.

[CLaNZeR]

Started doing some weighing and wind down tests with NO stator magnets.



The little 3mm RC bearings top and bottom give a good 4 minute wind down from 1000RPM with Rotor Magnets.

Find Video below:

http://www.overunity.org.uk/ocpm/tests/1000RPMCLaNZeRSRotor1.wmv

BTW I span it upto 4000 RPM without magnet just now and it started too lift off the table at 2500 RPM, so Blue Tacked the feet down and they are only just staying there at 4000 RPM, so be warned LOL 

Span it up with Air Line as below.


Off to find a bit of timber too screw then base plate too and add the extra weight !

Cheers

Sean.

[oak]

Hi Oak,

Thank you for the information! That is most helpful.

While looking through the links, I noticed this quote from Al:

Ahh, no. These tests have so far only been performed in my basement. I discovered the effect over the holidays, today was the first day back at the lab, and I had the unit disassembled for the bearing mod, and didn't put it back together till I got home.

(http://www.steorn.com/forum/comments.php?DiscussionID=59687&page=7&Focus=2266671#Item_22)

Does this mean that he had the unit working when the screw was still being used as an axle?

God Bless,
Jason O

That's how I would interpret what he said.