Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Thane Heins Perepiteia.

Started by RunningBare, February 04, 2008, 09:02:26 AM

Previous topic - Next topic

0 Members and 5 Guests are viewing this topic.

CRANKYpants

Quote from: aTg on February 22, 2009, 05:52:30 AM
http://www.youtube.com/watch?v=clCeqwevLXc

NICE WORK AAAALEXISSS!

AT SOME POINT IT WOULD BE NICE TO SEE BEFORE and AFTER DATA...

SUCH AS:

MOTOR INPUT CURRENT before LIGHT BULB LOADING = ?
MOTOR INPUT CURRENT after LIGHT BULB LOADING = ?

THIS WILL GIVE THE VIEWER AN IDEA OF HOW THE MOTOR IS REPONDING TO LOAD.
ALSO IF YOUR MOTOR IS TOO POWERFUL IT MAY NOT BE AFFECTED BY A SMALL LOAD?

CHEERS
Thane




aTg

Hello, Thanks for your interest in my video. will soon upload a video better documented.

My configuration is;

Small induction motor-2900RPM max 150W
30x5mm-diameter magnets
coil-0.6mm diameter (correcterd)

First test, the engine powered 60vAC connecting the load directly or 12v bulb and 5w to
resistance decelerates the engine to stop.

Second and video evidence, then add a rectifier and an electrolytic capacitor 100v 4700nF low engine
But revolutions are not stopped, the capacitor holds a charge and increases gradually increasing also the brightness of the bulb.
In my experiment, the rotor accelerates slowly but does not reach the same speed with no load on the coil, or at least to my knowledge.
The trial has lasted very little and got loaded up in the condenser 3v also lit the lamp.

I have something to improve security before the imam comes out flying somewhere near my face:)

CRANKYpants

Quote from: aTg on February 22, 2009, 08:49:30 AM
Hello, Thanks for your interest in my video. will soon upload a video better documented.

KEEP UP THE GOOD WORK!  8)

T

sushimoto

Quote from: aTg on February 22, 2009, 08:49:30 AM
Hello, Thanks for your interest in my video. will soon upload a video better documented.

Hi,
thanks for sharing this.
I do like your setup which separates the "kinetic mass"
from the electro-magnetical part of the system.
Thanes dentist would hate this kind of experimentation.. *grin*

2cent,
sushi

DAMIT DAS MOEGLICHE ENTSTEHT, MUSS IMMER WIEDER DAS UNMOEGLICHE VERSUCHT WERDEN.

i_ron

Quote from: aTg on February 22, 2009, 08:49:30 AM
Hello, Thanks for your interest in my video. will soon upload a video better documented.

My configuration is;

Small induction motor-2900RPM max 150W
30x5mm-diameter magnets
coil-4mm diameter


Very nice test setup aTg,  You should be able, with just a single coil, to show the Thane effect
if you can wind a coil with many turns of much finer wire....

Take Care,

Ron