Thane Heins Perepiteia.

[OilBarren]

Thanks Thane--the Megaupload video worked for me on the first try.  The resolution and quality are great.  Looking forward to Luc's video with the lightbulb as the load.

LOOK AGAIN JOHNNY - THERE ARE 8 LED's ON THE PROTOTYPE AND 4 OF THEM WERE HOOKED UP FOR THE SKEPTICS VIDEO. LUC AND I ARE GOING TO RE-SHOOT THE VIDEO AGAIN SO VIEWERS CAN DRAW A CLEAR LINK BETWEEN CURRENT FLOW IN THE COILS (i.e. LIGHTS COMING ON) AND SYSTEM ACCELERATION.

Thane

[innovation_station]

 

Thane  you dont want me to buy that now do you lol !!!!!

did you find with coils and higher resistance you get a better effect?

all i would have to do is wind a coil ......    hummmmm   


how hard could it be ...    lol

i did notice on 1 of your vids an ohm reading on a coil  as i recall it was quite high in resistance  170 somthing ohms if my memery serves me correct


but hey maybe that just dont matter ....  i just so happin to have a few miles of copper wire laying round lol!!

!st

hey here is a pic for you utilizing the kickback tech 

already availabile for sale   hummmmm   

what could i do with a few of thease .......   

[johnnyl]

Thane, yup, I missed them on the first viewing--my bad...  I see them now on top of the square frame around the motor--thanks for pointing that out to me!

[polarbreeze]

The LEDs (or a lightbulb) don't prove anything whatsoever. They're internal to the system. What you need to prove is that when the peripeteia is activated, the system delivers more power to an EXTERNAL load for the same amount of power going INTO the entire system. It would be a very clear demonstration to set up and it would prove the issue once and for all. It's such a very simple, objective and direct experiment. Why would you not do that?

[LarryC]

The LEDs (or a lightbulb) don't prove anything whatsoever. They're internal to the system. What you need to prove is that when the peripeteia is activated, the system delivers more power to an EXTERNAL load for the same amount of power going INTO the entire system. It would be a very clear demonstration to set up and it would prove the issue once and for all. It's such a very simple, objective and direct experiment. Why would you not do that?

My testing of the Bi-Toroid generator design has proved Thane's theory that a decoupled primary uses the same wattage with an open secondary or a loaded secondary. See reply 566, generator test 4 and 5.

Regards,
Larry