Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



how can i change the amps to .5,1,1.5,2 etc to condition my rods.

Started by jas_bir77, October 26, 2008, 01:02:30 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

jas_bir77

October 26, 2008, 01:02:30 AM
hi,
i am using the dave's curcuit d-14 updated on 12 feb 08 only diff is that i am using the mosfet of higher value coz i was unable to find buz 350 rest of my wfc is according to Research Paper on Ravi’s Water Fuel cell Replication updated on 15-08-08.in the above curcuit when i connect it to the battary i get a constant amp reading of 1.46-1.50 amps & if i cut the 220 +820 resistance going to the -ve side my amps goes to 2.5amps & stays their (when i cut this resitance from the -ve side my resistance is still connected together & going to pin 3 of the 2nd 555 ic & the mosfet is also connected i simply cut the wire of the 820 resistance going to the -ve side.kindly tell me how can i change the amps to .5,1,1.5,2 etc to condition my rods

jas_bir77

#1
October 26, 2008, 02:22:33 PM
in Research Paper on Ravi’s Water Fuel cell Replication by Panacea-BOCAF On-Line University on page 38 their is a message posted which says Message: "I have duplicated Stan Meyer's work, and have taken it several steps forward. First, during assembly of the generator, I have found that you must tune the tubes to the same pitch. I do it with a simple guitar tuner. Just clip it to the tube and strike it with a small brass (to prevent polarization) hammer. The easiest............goes upto........I don't add the toroid until final assembly, and try to maintain a 1/8' gap from the top of the tubes to the toroid. I am currently running 70psi in the generator. -End".
can anyony anyone explain "and try to maintain a 1/8' gap from the top of the tubes to the toroid".   

uki

#2
October 26, 2008, 03:21:24 PM
Toroid was used as a electromagnet with low frequency (20Hz) 1:10 high frequency is for electrolysis, up to 10KHz.
Magnets  affect the bonding angle between the hydrogen and the oxygen atom in the water molecule.  Magnetized water causes the hydrogen-oxygen bond angle within the water molecule to be reduced from 104 to 103 degrees. Only like that is possible to get massive production with low amp. Google it.....(Magnetized water)
Print
Go Up Pages1
User actions