Roll on the 20th June

[The Eskimo Quinn]

refresh

[madsen]

refresh

I've seen both the videos you just linked to, but this is a good chance to ask a couple of questions: 

• Referring to the "broken wall" video", what do you believe a "Newtonian" physicist would predict would happen when you release the roller?  How would it move differently?
• Do you claim that at any time in the broken wall video, the total energy (kinetic + potential) of the roller increases? 

ETA:  The potential energy possessed by the roller is due not only to gravity, but also to the magnetic field.  The roller actually has more potential energy at the 9 o'clock position that it does at a higher position (say 10 o'clock).  You can feel the magnets pulling the roller upward before you release it, right?

[Rusty_Springs]

just a thought here but....

has anyone tried placing a coil around the ferrite, in attempts to collect the collapsing field when the 'switch' contact is broken???

{EDIT} - my thinking behind this lies in my experimental evidence that the induced field in the ferrite is stronger than the field at the contact-point.

meaning it takes less energy to remove the contact-point, than it does to remove an object from the magnetized ferrite.


So, it stands to reason the colapsing field would provide more energy than it took to remove that small pin.
Mechanical Inductor/Generator anyone?

Hi Sm0ky2
If you read the site I posted that had me talking about the magnetic current about 2 years ago you would have seen that I talked about using coiled magnetic wire or iron wire and it didn't seem to make any real differance.
Take Care Sm0ky2

[gwhy!]

Hi Archer,
  Sorry to keep bothering you as you must be a very busy, Sorry where did your roller start from a standing start. If the roller was not moving how it start ?. I thought you put the roller into the attraction area of the track. Now Im getting very confused 

[AB Hammer]

Bessler covered springs, pulleys, weights, ect. that made his wheels operate.
He actually states this in some of his writings and drawings, but a lot of Bessler "fans" seem to overlook this blatent fact.

So is it your intention to hide these sort of working mechanisms under your 'coverings' ?? How will we know that your wheel is truly PM ?

Full circle video to show nothing attached except the rope holding it from spinning. Then releasing the rope and watch it go. Then stopping it and let it do it again and again. The rest you will have to wait on. But it will have to be restrained to keep it from spinning.