Is Lindsay?s ?SM? a fraud?

[otto]

Hello all,

@Gustav22

thanks very much.

@All

I wanted to show you a new TPU design. I made it first with a Metglas magnetic alloy core. It worked good but the heating was a big problem.

So, the picture showes a STAINLESS STEEL CORE TPU. Not soooo a big heating anymore.

Collector coil: 9 turns lamp cable
control coil: 60 turns for each quarter, bifilar, wire diameter 0,5mm
core: stainless steel, 2 halfes, outer diameter 6", inner diameter 4"
Core cutted by hand , not to overheat the steel because the non magnetic properties would be lost.

This is just 1 half of the TPU because I see that another ring is needed.

Otto

[poynt99]

Its the first time that a conbination of 245kHz and 35kHz works somehow.

well unless you tried this combo with a 15 inch diameter device you wasted your time. but i guess you didn't pick up on the clue that diameter and circumference changes mean a change in frequency.

[altium]

Thank you very much, Otto.
What`s your frequencyes? Are the freqs sinhronized or you  just use 3 single independent generators?  What`s power consumption of your supply?

[weri812]

to Gustav22 and Otto

like your drawing
is the core wound in a bucking  byfold  like   N---N   ??

thanks
GOD BLESS
wer

[wattsup]

@otto

I don't get your new stainless core. You say it is 6" O.D. and 4" I.D. That will give you a 1 inch thick core. So how high is it? Please say 1/4". lol

Geez, how heavy is it?