Infinity Coil

[z.monkey]

Howdy Y'all,

Looking at the Xabbard-Coil.jpg drawing, it seems that each independent LC circuit would need to be tuned independently to the same frequency.  You would need uniform coils and equal caps.  Then for the center coil and the isolation transformer you would need to custom fit the capacitance to match the uniform peripheral LC circuits.  By getting everything to resonate at exactly the same rate this circuit could be the self sustaining generator we have been looking for...

This is a picture of their build...

Blessed Be...

[4Tesla]

Glad to see ya back and working on this! 

Jason

[z.monkey]

Howdy 4Tesla,

Yeah, I ran the gauntlet this summer.  I don't think I have ever worked so hard, ever.  My wife is a cruel slave driver.  So, do you have any opinions on this new information from the Russian free energy website?  I have it running around in my brain.  I am kind of scatterbrained because of all the different concepts for just this on transformer setup (Infinity Transformer).  No I not only need to learn German to read Victor Schauberger's books,  but I need to learn Russian to read their free energy website.  Uulgh...  The never ending learning curve....

Blessed Be...

[4Tesla]

I still don't understand how this works, but looking at the site.  Here is a link to translate with Google:
http://www.google.com/search?q=http%3A%2F%2Fwww.skif.biz%2F&ie=utf-8&oe=utf-8&aq=t

Click on the "Translate this page" link

Jason

[z.monkey]

Howdy Y'all,

Referencing the Xabbard-Coil.jpg drawing above notice that there are LC tank circuits on all the secondary (I think) windings that are only inductively coupled to the rest of the circuit.  I think this circuit is starting to resonate in my brain.  The LC tank circuits keep the device oscillating.  While the primary coils on all the cores are for interaction with the outside world.  The center coil (Zylinder in der mitte) is the output which is coupled through a isolation transformer to supply the output.  This output is also full wave rectified and is fed back to the primary coils on the peripheral cores (8 Zylinder auBen) which are wired in series.  The isolation transformer is an unknown, but it graphically has equal length coils so it would seem to be 1:1 winding ratio.

I am good at winding coils so that is no problem.  But we have few details here other than the schematic.  Assuming that we want all the tank circuit to resonate at the same frequency then we could calculate or measure the inductance of the coils, then extrapolate the value of the capacitor by solving the resonant frequency equation for C.  Then mix and match caps to get exactly the right value. 

I had always figured that the self sustaining electric generator would work like a tank circuit, but this is not what I had in mind.  The Xabbard-Coil.jpg schematic has 12 LC tank circuits in it.  So this circuit is pretty close to what I have already.  I'll need an isolation transformer to set it up.  I need to figure out the inductances on the coils that I already have wound, then get the appropriate capacitors.  So then I only need to wire it up.  I think that I am going to give this arrangement a try next.

Blessed Be...