Biowerx Work

[Rosphere]

@biowerx,

Here are some photos of some work that I did this morning with the parts that we purchased yesterday.

The main jet shoots up 36 inches, from the top of the unit, using the 1/2" fitting alone.

Using all nine nozzle ports makes little droplets, not so much a fine mist.

[biowerx]

So....
Wonder what the spray would look like with the manifold half plugged or eight plugged ?
Wonderful job so far !!! Good luck with your DIY bidet 

[Rosphere]

....Good luck with your DIY bidet 

Note to self, use warm water next time. 

Open Source Aeroponic Design
By biowerx and Rosphere

[biowerx]

As Mr. Burns would say:       Excellent....   

[biowerx]

Right!!!

So... seeds or cuttings could be inserted inside an exposed net pot or mesh pouch hanging down through the holes . I gotta wonder if an ultrasonic fogger could be alternated with the low pressure mag pump ( both timed to allow for roots to breath ) for maximum coverage.

Here's some of my  ta-duze
 
   Looking for a range of 5 to 100 micron droplet size.
   Sterilizing tub and accessories with diluted H2O2 and distilled water.
   Germinating by moist paper towel , gauze and will also try bio dome trays with a monocrop of either 
   Ginseng or Crocus sativus for fast results.
   Seed priming overnight. Under tray heating mat between 74 -80F
   Get fogger from Rosphere in exchange for my working TPU  - sorry
    If tub can't germinate seeds, I'll put the sprouts in tub holes after the seed leaves have gone -
    (Neoprene inserts). Caution handling the delicate stems and roots and watch for damp off.
    After biomass destruction, call Monsanto for patented, gm seeds and more Roundup.