this pyramid should produce electricity. (thomas trawoger's pyramid explaned.)

[nitinnun]

CCW, is attracted to water molecules in sky (attracted, to waters hydrogen atoms).
pyramid allows CCW, to climb high into sky.

pyramid, is like up-side-down pot-hole.
CCW, is water filling up pothole.


CW, is attracted to sand in ground (attracted, to sands oxygen atoms).
CW is stored in sand/gypsum/granite, that pyramid is made of.
CW slowly fills up sand/gypsum/granite in pyramid, starting from peak, moving down to base.

pyramid, is like baseball-glove.
CW, is like baseball being held above ground, by baseball glove.


when CW touches ground, CW overflows into ground.
resistance in ground, slowly eats up CW.
until CW is used up.

[Tigrotto]

Hi Nittun,
but finally , as you know, did someone to put in practice what you suggested here about how to collect electric energy by means of a pyamide?
Tigrotto
P.S.
I said here many times : I currently "collect" energy charging my batteries using a normat cardboard pyramid!
I need to improve my system , but I need to know if some of you put in practice your ideas.
I saw here tons of ideas but no one o them saying as example: I did switch on a LED.So: Does make sense the theories???

[nitinnun]

i think that the pyramid, works EXACTLY like the winhurst generator.


on the wimhurst generator,
clockwise magnetism builds up, on the clockwise spinning wheels.
counter-clockwise magnetism builds up, on the counter-clockwise spinning wheel.

these 2 magnetisms, are combined into electricity.


on the pyramid,
clockwise magnetism builds up in the middle.
counter-clockwise magnetism builds up above the peak.

these 2 magnetisms, are combined into electricity.



i think that HIGH FREQUENCY ELECTRICITY,
can be used to GREATLY increase the output,
of the wimhurst generator.

while the pyramid might require high frequency electricity,
"to work at all".

( thomas trawoger had an oscilloscope attached to his pyramid ! )
( which means his pyramid had high frequency electricity going through it ! )



ironically, the "overunity torroid" ALREADY uses high frequency electricity, to do the same thing !
my idea is just to replace the torroids "main coil", with a wimhurst !


a wimhurst is already its own power supply.
so that solves one or 2 of the major problems, with the overunity torroid.

[nitinnun]

by the way.
to "disrupt" the whimhursts magnetism, i wanted to:


* place the 2 wheels, between a horse-shoe magnet.

* wrap a wire coil, around the horse shoe magnet.

* charge the wire coil, with high frequency electricity.

the high frequency would travel through the magnets magnetic field, and into the wimhurst wheels.
disrupting their charges.



i also think that more voltage/amperage could be produced,
by plating one wheel with thin copper foil,
and the other wheel with thin steel sheeting.


i even want to attach each wimhurst wheels, to its own 20 inch wide box fan!
to get high speed, for little power consumption !


the only problem, is that i'm scared to build it.
because the arcs might be powerful enough to start a housefire.
or to kill somebody......

[amigo]

Hi nitinnun,

I watched a rather old documentary last night from Les Brown - The Physics of Crystals in which he spoke about similar concepts that you described earlier regarding pyramids.

The difference is that his findings are that there's no CW motion inside the pyramid, never ever. The pyramid only produces what he termed "gravitation" of magnetism in CCW direction, spiraling from bottom up. At the tip of the pyramid we have the flip and the "gravitation" turns into "radiation" which rotates CW.

The CCW gravitation is "negative" energy, while the CW radiation is "positive" (not electric polarity wise but magnetism).

The pyramid itself according to Les has three zones, where the energy increases by a level of magnitude as you move upwards. There are two points of interest, obviously one 1/3 and the other 2/3 of the height going up the central axis.

From my further research on pyramids, it appears that they are affected by the strong magnetic fields. Pat Flanagan did some experiments with the ones similar in proportions to the Great Pyramid one.

The basic rule for them is that one side must face the magnetic North in order to obtain maximum effect. He found that if the pyramid is put within an artificial magnetic field, of two bar magnets for example 300 Gauss, it did not matter whether the pyramid faced magnetic North of the Earth anymore as long as the pyramid was aligned to the magnetic poles of that artificial magnetic field.

Incidentally, Pat believes that at one point in time in the past, both magnetic and True North were aligned and in the same point/axis but over time the magnetic North veered off and as a consequence the Great Pyramid is not active anymore.

Just some food for thought.