Another YouTube Claim

[CLaNZeR]

Seems like Silly Season has begun, here is another 

http://uk.youtube.com/watch?v=PR_o0E7nvEM

[TheOne]

lol, coil under the table

[therealrasta]

Seems like Silly Season has begun, here is another 

http://uk.youtube.com/watch?v=PR_o0E7nvEM

If only it was that simple..

edit -- if any of you are crazy enough to try this.. use tape and not super glue. 

[Hugo Chavez]

I think it's great that there are so many clowns like this fully willing to waste everyone's time.  They make it harder to pick out the good ideas for consideration. I could think of a few jokes I'd like to play on their faces

[Thaelin]

   AWWW come on guys and gals. I would not even try to call this a hoax. This was just plain fun all the way. He let it run for a bit and then when called on it, spilled that he was in fact into video and it was just video editing. Clean slate and a good job of it too. 

  On the other side of the coin, if you had two platters with same poles out then it would bend it down trying to get to each other. Total lock up. Like poles and you will indeed get a mag bearing like the one I made. I bought a bunch of ferite 8's and made on ten inches in diam. Rotor had mags both sides set to an angle and two rings on the outside so it sat in a well. No way to balance it right but that thing would spin forever on  a good hard push. And, there was no cogging, but you could feel a slight irregularity in the rotor if moved slowly.
   Using small round mags, it would be easier to make that smaller and more strong so the outside of the rotor could be used for something useful.

thaelin
 

   And... you notice, it had magnets and Clanzer was all over it. The man just loves magnets.