Fueless Friction Heater Manufacturer Found

[Cap-Z-ro]

There are many sites showing diagrams...if I can heat my place for under $100.00 it will be worthwhile...test results forthcoming.

I think its going to take Gustav Pese to resolve my torque problem...he's the man to go to for problem resolution.

Regards...

[helmut]

There are many sites showing diagrams...if I can heat my place for under $100.00 it will be worthwhile...test results forthcoming.

I think its going to take Gustav Pese to resolve my torque problem...he's the man to go to for problem resolution.

Regards...

Hi
You might look after this circuit. And this cost here    53.34Euros

[helmut]

Hi Alan
The next pic show another circuit and a grinder just to show what i mean with grinder.
There are many ways to help you out with some information.
Gustav Pese might be able to sell one device to you.

[noonespecial]

There are many sites showing diagrams...if I can heat my place for under $100.00 it will be worthwhile...test results forthcoming.

I think its going to take Gustav Pese to resolve my torque problem...he's the man to go to for problem resolution.

Regards...

OK, I'll wait to see your test results. However, as I mentioned in an earlier post, I've personally seen one of these running before. It will definitely generate heat but unless you are getting your electricity for free will be more costly to run than a standard $49 baseboard electric unit simply because of the efficiency factor.

Regards,
Charlie

[Mark69]

@Cap,  I was thinking of using the thermostat to control a relay and the relay would control the electric motor.   I dont think the termostat would be able to control the electric motor directly, but should be able to control a relay to do the job.

Mark