Joule Thief

[innovation_station]

Use a copper coil as a core.  Bias the core so that the magnetic field produced by the core transmits the induced primary current  I think that is what innovation is up to,  Nice wraps too.

J your picture at the last seams really bright!  .. great job .. 

sparks

try trifillar pancake ..  1 shorted the other powered with the jt and the last tuned couppled not electrical contact .. and force feed ... i think it will be darn neat .. there is sooo many ways .. this is why i have been confusied in the past! 

w

[jadaro2600]

A recurrent theme here on the thread - oscillations.  I noticed, here on Earth, that it gets its coldests towards the sunrise on winter nights.  This isn't always the case, but in calm weather ( such as a stationary front or the tail end of any front), it seems to be the norm.

Keeping the joule thief in mind - a toroid may best be used to create the same sort of momentum of magnetic flux.

I find it unusual that there seems to be a momentum of cooler temperatures just as the sun rises.

This may be a rehash of an old idea, but if the jtc were a better tank, then the capacitance of the circuit as well as the resistance to base should both be tuned - I think we could gain the same sort of momentum.

I see the same effect in clouds, where the stratocumuls clouds will go in one direction and the cirrocumulus clouds will go in another - quite often I see these moving at right angles to one another.

[Pirate88179]

Hey:

Here is a video of a fellow firing up a ten watt LED!  I never even heard of a 10 watt LED but it sure is bright:

/www.youtube.com/watch?v=BkUGNtYKasU&NR=1&feature=fvwp

Now, he is using 12 volts and 800 mA's but, I'll bet we could run one of these on a lot less, probably Jenna can run it on her 1,500 volt circuit?

Bill

[FreeEnergy]

Bill did you get my private messages?

[innovation_station]

so today im digging through  boxes full of boards i made .. in the past .. looking for driveing curcuits . so far i have found many bedini 's  that i bet work great with this unit ...   and i think they are portected units .. with a neon and a FEW diodes ... also i have tonnes of mosfet driver boards too...

so i hope to put it togather today ..   i have other curcuits the same as the bedini i spoke of which wile in demo  blew a meter .. up in smoke ..  and its out put around 350vdc x6 feeds .. 1 freq ..

i think we were able to mesure from some of them ..  over 220ma... that was just the fly back .. agin that unit is diffrent ... than what im working on now ..  but a good curcuit .. i have failed to blow up 1 3055 with that board .. and because where the diodes are ... however i did burn a few small resistors out ..   in the configuration i just spoke of the trigger colpase is added to pulse ... in the design of the board ..

ist! 

right i forgot it is air core .. that tpu .. it was showen on overunity .. maybe 1.5 years ago ... it might even be 2 years now ...  yikes ...

i built it fully public too ...  same old   same old ..