Joule Thief

[jeanna]

I only ask because I have used neos on and around my cores and you can easily hear the frequency changing.
...

Yes, the frequency doubles and the voltage plummets when you stick it onto the core toroid. I have not tried to see if it would stabilize it.
Right now, I think I am getting overloaded with unanswered possibilities.
So, I cannot take on anything more for myself. I am glad to look, though.
I just ordered a LC meter today. That ought to help me. I am struggling with inductors and matching them to each other and to caps.

thank you,

jeanna

[Yucca]

The circuit below is what FreeEnergyInfo references.

I will be building one when my HV caps arrive, it´s a joule thief with a really high turn tertiary winding (basically a flyback trafo). The really high voltage low current output is charged into the output cap until the spark gap breaks down and then it´s dumped through the filament lamp. You´re supposed to be able to light line voltage household bulbs using low input V and I. If that´s the case then maybe the bulb could be immersed in water and then measure the temp rise and see if more joules of heating are performed than joules inputted into the circuit, in which case OU is achieved.

[innovation_station]

hello everyone ... im a little out of commission for a few days ...

but i was at a friends yesterday takeing apart my 600v 30 hp motor and my 7 hp 550v  oooooo i got me an idea ... 

so when i was there my friend dugg out a carbon rod heater from the 30's ... 

and an iron wire heater ...    he says if i can make them work  for him he has a gift for me ....

i said  ok a deal ...  i never made the heaters run but i know they will ... 

my gift was a 1932  battery powered tube super heterodyne radio ... 

o boy  my jaw hit the floor when i say it ... 

i have it here with me now ...  i fell in love with it as SOON AS I SAW IT !! 

i will be building a huge pulse motor from the remains from my big motors ... 

YES A REALLY BIG ONE ...  A FEW HUNDRED POUNDS ... EACH ... 

i will make a large rotor loaded up with weight then i will power it from a pulse motor coil ... and a 12vdc battery ... my plan is to get the large mass ripping ... 

then i will use 2 gear reduction boxes .. to increase the torque and drive a few 12v 40 + amp altonators .. 

plus im stripping the copper from the motors i will also use the lamanited cores for some tpu rings ..

i call them a tpu but really it will be a pulse motor rotating generator and a colapse recovery unit .. ..


i found out yesterday my neibour is a electronics dude ...  specialized in computer controled electronics ... 1 more year he sayd he has a uni deg in electronic engineering ...

i said REALLY ...  got a week to build my teleportor ... ?   and i showed him my radio...   

he never answered on the portor deal ... but his ears perked up 

ist!

[jeanna]

Hi everybody,
While I wait for my LC meter I have been making videos. 

part 3 finally:
http://www.youtube.com/watch?v=y6pbzrhBR-8


It failed last night. The audio was removed and I needed to re-compress it and re-upload it.

This is over 8 minutes long, so be warned... I need to let them buffer when they are 8 minutes long!

I hope you enjoy it.

jeanna

[dllabarre]

While I wait for my LC meter I have been making videos. 
jeanna

I'm looking for a L/C meter now.
What did you get and where did you order yours from?

Thanks,
DonL