Joule Thief

[Tink]

Gadgetmall,

I get the impression you didn't watch the movie, I think you should because it explains the OU effects of resonance in LC circuits.
Maybe you somehow created a similar circuit around the basic Joule-thief by accident.
What I mean to say is that it looks like your circuit is indeed OU.
Please have a look at the movie I gave you a link to.

[sparks]

     @tink


   NICE

  Resonance is right there in your bifilar windings folks.  The capacitance of the lc tank is right there due to the geometry of the bifilar windings.  Energy from the past accumulates in energy of the now. Grumpy explained this in the past many times.  As did Tesla.  As you swing a hammer you are storing the conditions of the past energy disbursement which creates reality into a timeless inertial frame.  When it pops back out into the new time snapshot of energy it has been amplified by hiding out independent of time.  A little gets radiated by the friction of the air but it is minimal.  When you allow it to pop back into the now stuff starts happening in the energy domain at tremendous velocities because the spacetime continoum itself is trying to rectify the excessive energy entering it's time.  Where did all this energy come from.  The past of course.

[gadgetmall]

? It read the same on both meters swapped . Also all current was done on Dc settings . The one showing 21.88 milliamps is a fluke meter set on Dc amps in the 300milliamp hole . I found a supplier but has a 100 part min order so i'll keep looking .
http://www.mouser.com/ProductDetail/Vishay-Dale/RW67V1R0B12/?qs=sGAEpiMZZMuQ5%2fsBR7SoAsgb9Zkfwd140SoGinADYIY%3d

[innovation_station]

here is a picture of the unit i made last night

i have 5 wired feeds from just trigger colpase .. also useing other places of tap to compleate the circuit ..  i can add more ..

each wire has its own reading ... i have not done this to the pulse wire yet .. nor the transformer secondary


i can take all readings with out effecting the operation of the unit .. all tests were done useing 1.5vdc source ..

thank you

w

btw ....   i drop a cam cap on it ... 29 volts right away ...  short it .. 29 volts right away .... lol

that was only 1 feed ....  hummmmmm

[MrMag]

? It read the same on both meters swapped . Also all current was done on Dc settings . The one showing 21.88 milliamps is a fluke meter set on Dc amps in the 300milliamp hole . I found a supplier but has a 100 part min order so i'll keep looking .
http://www.mouser.com/ProductDetail/Vishay-Dale/RW67V1R0B12/?qs=sGAEpiMZZMuQ5%2fsBR7SoAsgb9Zkfwd140SoGinADYIY%3d

The signal coming off of the jt is more of an AC wave or pulsed DC. If you want to measure it as an DC current value, I think you would need to rectify the output first.