locating Steve Mark´s TPU demonstration house

[kames]

so i hooked my bifillar resonant couppled coil up to my scope just for fun fired it sine waves and well i found the coils resosance lol and to my surprize supper spike sine lol 

i will post the pic this is perfect sine fed to my coil from my tube freq genny ...

ist!




there is no connection from the freq genny to the scope THE CONNECTION IS MADE IN THE COIL  the pic is of the out put side of my polorized coil

i better do 1 more pic showing the inputted sine wave... and the out put wave...  lol

Under an active load?

Kames.

[innovation_station]

no load....

this is where you go wrong....   errrr

im going to post somthing i am currently going to test.... 

build it test it PROVE ME WRONG



this may cause EMP'S......    test low voltage only !!!   

i do not know the results of slamming the coil this fast.....

btw my scope shot is only to show the connection at RESOSANCE made in my coil  input side to out put side ...  with the input we ringgggg the output duh!!!!  and we collect the input side coil hemf backfire to the next cap....   fire it to the next coil .....   the output only becomes active at harmonics and close to the fundemental freq  of the tuned coil ... 

if sm's tpu is as stated above    .....    then i guess you all just got a better toy .... 

ist

gonna get a pic 4 all of you ...   coil and curcuit

[innovation_station]

as i said....  i have made this my own.....


ist!

[Antimon]

Something that most do not keep in mind, is that SM's writings can be interpreted in many ways and made to fit into many different theories, all of which remain theories until proven otherwise.

In summary, we can't make blanket statements like: "this is how it's done", or even "this is the basic principle" unless we actually have access to a device operating that way and have PROVEN that it is OU.

.99

Why do you know that we haven't proven it yet?

A.

[innovation_station]

i used the irf840 mosfet as my GATE KEEPER 


ist...

if you were to use this in a 3 coil setup then i would take the output coils....  and run the output through the center of  the electro magnets as per ottos test and accelerate the returned engery not the inputted hot engery

i love this part i must say it AGIN .....    let a single charge of cap 1 be first considered.....    


i was thinking of building a 3 coil unit but all i have right now... is  single coils....  none the less ill whip 1 up 

i need 1 anyways.......