Feedback To Source

[jadaro2600]

So, the copper acetate has become somewhat of a mystery.  Adding more hydrogen peroxide to the vinegar results in less crystalization of the copper acetate.

I was planning on using shrink tubing to create a graphite diode with copper acetate as the oxide for the carier.  It would be nice if I could get the crystals to become more solid, they seem brittle.  I had a few that were easy to see, easy to pick up and look at and were approximately 1/8th of an inch or so , however they crumbled rather easily.

I'm going to start a new solution and add only a little hydrogen peroxide so that the formation of peracetic acid is lower that what it is now.

More updates later.

[nievesoliveras]

@jadaro

Good luck with your experiments.
I think that if the crystal is brittle and you are using shrink tubing, anytime you accidentally bend the tubing the continuity of the crystal may be lost.

Jesus

[nievesoliveras]

@all

It seems that something is missing on this circuit.
I have not been able to make it work as the logical circuit reading stated.

Maybe it is better to build a reed switches commutator to activate the transistors.
One reed switch should activate first, then the other in secuence.

But what I wanted was to make it as simple as possible with just one transistor as the switcher trigger.

Jesus

[nievesoliveras]

@all

Still studying. Here is another circuits composition. Logic circuits.

Jesus

[nievesoliveras]

@all

Here is another group of logical circuits. I am almost sure that the answer lies on these circuits.

Jesus