One wire transmission: Tesla and Avramenko

[Pirate88179]

Thanks.  They are brighter with both wires as you can see in my other videos on there but, I just thought it was interesting that the light at all.  100 was my limit for the one wire tests.  with both wires running the 100 leds, they are almost too bright and I don't run them very long as I do not want to burn them up.  But, 400 leds is my limit for now using both wires.

Bill

[pese]

ive attention. IF this is HIGH FREQUENCY /RF) even low frequency square wave)
This it is not one wire transmission. !!
Its an cloused ring circuit !!. (Oszillator Antenna Capacitor (load) Ground Oszillator )!!

Because RF  even LF square wares conduct over capacities the loads (as xenon (Naudin), as fluiorescent lamps as neons as led
(an even-if you have hi power, also bulbs (filament glow lamps.)

Square waves (even if low frequency if the have very short ( switch t(on) and t(off) times
(see datasheets 555  if thas was used for example.
so that say if the output voltages are transferred via
condensor (even if only picofarad ranges ,
so your power will  be transferred.  (capacity resitance ).
-------------------------------
50 years ago ..... if i have connected  my Shortwave transmitter (100 watts)  in serie of an lamp (filament normal lamp 60 watts) to  the  "One wire" SW antenna . The lamp will glow up bright.
----------------------------------
So what Naudin and you do , is nothing other !! (in milliwatt range.)
No wonder over that, if you collect some parts of MILLIwatts,
that LED will burn . IF the wiring of this is the antenna,
and your hands or other parts around is the capacitive ground or the load,  so the oszillator circuit stend power to the output
(antenna)  and the controlling load resistor (replaceed here with lamps,) glow up. I am wondering since years that nobody will
shown this examination, but designs schemas over schemas over this very simply technic that (must) know even any  radioamateur-

Gustav Pese

[jadaro2600]

ive attention. IF this is HIGH FREQUENCY /RF) even low frequency square wave)
This it is not one wire transmission. !!
Its an cloused ring circuit !!. (Oszillator Antenna Capacitor (load) Ground Oszillator )!!

Because RF  even LF square wares conduct over capacities the loads (as xenon (Naudin), as fluiorescent lamps as neons as led
(an even-if you have hi power, also bulbs (filament glow lamps.)

Square waves (even if low frequency if the have very short ( switch t(on) and t(off) times
(see datasheets 555  if thas was used for example.
so that say if the output voltages are transferred via
condensor (even if only picofarad ranges ,
so your power will  be transferred.  (capacity resitance ).
-------------------------------
50 years ago ..... if i have connected  my Shortwave transmitter (100 watts)  in serie of an lamp (filament normal lamp 60 watts) to  the  "One wire" SW antenna . The lamp will glow up bright.
----------------------------------
So what Naudin and you do , is nothing other !! (in milliwatt range.)
No wonder over that, if you collect some parts of MILLIwatts,
that LED will burn . IF the wiring of this is the antenna,
and your hands or other parts around is the capacitive ground or the load,  so the oszillator circuit stend power to the output
(antenna)  and the controlling load resistor (replaceed here with lamps,) glow up. I am wondering since years that nobody will
shown this examination, but designs schemas over schemas over this very simply technic that (must) know even any  radioamateur-

Gustav Pese

By these statements then, I can assume that there will be RF losses due to the one wire emitting electromagnetic waves?

[pese]

All that is used in loads (leds , light, calor etc
was powered from an source. EVEN IF IT only
(invisual) capacitiv connected . (as second path ,
that can peplace the missed 2. wire).
i think that is short and to understand my knowledge
from them...
G.Pese

[jadaro2600]

It would be interesting to know if anyone's done anything with this lately?

I couldn't find any 555 timers, And i've lost my breadboard, ... SO I went to the local radioshack and those people don't have any answere's, so I looked for another source of IC logic chips, Apparently Texas Instruments will ship free samples to people, so I requested 2 types of 555 chips, and 2 556 timers. Additionally, a chip called the TLC2272AMD - just for fun. And for FREE btw, shipping costs and all.  It's good to be a student.

Perhaps one of you could enlighten me as to what the voltages are across the one wire - . I was thinking of using these camera batteries, these 3v 123 Photo lithium cells, or maybe some rechargeable.

Maybe I'll just use the AC hobby source and rectify it for the purposes of running the timer chip.  I'm a little lost on all of this though...there would be no point if I have a pre-existing AC source now would there?  I can just run the...

Wait, how does this Avramenko circuit work again? LOL.