First electrical power output from a Pyramid

[vipond50]

Good Point Pontitex
WTF?
You just said it better than I did
Hmmmm.... Was here and did not say Sh*t ?

Could say more, but what's the point.

B.

[helmut]

Hi all,

Thomas is back with great news!!!

http://trawoeger-pyramide.info/


there is also a new yahoo group for the TTP project.

http://groups.yahoo.com/group/pyramide-project


cheers

atlantex

At least : good news

Otherwhise he discribes in his Guestbook a story ,sounds like Nightmare.
That he retourns is a proof,that he is a brave Guy.
With luck all Replikatioins will give out some current till Xmas.
helmut

[neptune]

Magpower, I notice there is a big difference between the resistance between short graphite rod to copper tube, and long rod to tube. This suggests to me a possible break in the short rod. Others have had this problem without realising it.

[duff]

I am closing the gap - frame together, painted and gypsum going on now.

Last night I cut my copper tubing tomorrow I will start on my capacitors.


Thomas is inspiring and is setting the mark high for us to live up to...


I only wish I knew the full history of this device. It's hard to make intelligent construction decisions without it.


-Duff

[magpower]

Magpower, I notice there is a big difference between the resistance between short graphite rod to copper tube, and long rod to tube. This suggests to me a possible break in the short rod. Others have had this problem without realising it.

Each of my rods 90mm and 95mm measured approx 20 ohms, end to end, carefull not to break. And don't touch either. Now you connect 1 wire to each end and insert into tube, put sand around rod to hold in place, don't move it or will break. Now with ohm meter with one on tube and the other on wire you should have 0 ohms, or open circuit. I will post a pic later. But this is how I see it and no expert, just trying to steer the ship.

Once in tube its really hard to know if its broke, I did break 2 rods already,this step is tricky, the rest we see.