Stanley Meyer Explained

[Toolofcortex]

.

[kolbacict]

Unfortunately, I just can't experiment with a cell and a circuit. I have to spend time repairing equipment to make a living .not enough time.

[Toolofcortex]

Its Ok Kolbacit, this is too much for you.

Despite your clear ignorance and lack of education, you proved to be an exeptionnal user, hard worker. You work alot and you talk little.

I'm sure that if you were given 2700$ and this circuit, that you could do much more Hydrogen than anybody before. 

[h20power]

Unfortunately, I just can't experiment with a cell and a circuit. I have to spend time repairing equipment to make a living .not enough time.

I understand as this technology takes a lot of time and money to get the things needed built properly and testing underway. Just trying to take temperature change readings over time properly can eat up an entire day or two.


People look at the cell I am using and have no idea just how hard it was to get it made for me by a local machinist where I live. They don't understand that a machine shop will not make just one of something, well not at a cost that anyone could afford anyways. Most have a minimum make amount that must be paid in full before they even get started most of the time. I had to make eight of these cells minimum with a total cost of around $13,000 bucks. It's not a cheap technology to have built let alone the time one must sink into making and revising the VIC transformer that will have enough energy to be able to charge up the cell. Which by the way cost even more than making the WFC cells as again you will run into minimum buy amounts as the core cost $358.40 with a minimum buy of eight and you don't even get a price break unless you buy 50 or more units. Same for the wire as you can't buy just what you need as you have to buy what ever minimum buy amount they offer for the right type of coatings, sizes, and types of wire you need. Most people have no idea of these cost as they never get to point of building anything.


I'll keep at it as I have come this far and now can see the light at the end of the tunnel,
Edward

[Toolofcortex]

Maybe in those years.

But nowadays, developping machine shops in china offer extremely competitive pricing, and anything out of delin can be turned with a 500$ lathe on craigslist.

3D printers are more affordable.

Its up to the CTO, chief technology officer to make every dollar count and plan everything from design to manufacturing.

Its not hard to manufacture high tolerance jobs, anybody can do this.

Of course, if you listen to these bullshitters, open your mouth, and say "fill me up honey", you are gonna pay a bit more.